Home › Drivetrain › K313F (MULTIDRIVE / CVT) › CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM
RM32H0E _52 Drivetrain _059618 K313F MULTIDRIVE / CVT _0300013 CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM D

K313F MULTIDRIVE / CVT  CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM  DTC CHECK / CLEAR  


HINT:
·

DTCs which are stored in the ECM can be displayed on the GTS.

·

The GTS can display pending DTCs and current DTCs. Some DTCs are not stored unless a malfunction is detected in consecutive driving cycles. When a malfunction is detected in only one driving cycle, it is stored as a pending DTC.



CHECK DTC (Using GTS)


a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Powertrain / Transmission / Trouble Codes.

Powertrain > Transmission > Trouble Codes
50001 373

e.

Check for DTCs and freeze frame data, and write them down.

HINT:
GTS Display Description
Test Failed Shows the malfunction judgment results for the current trip.
Pending Shows the malfunction judgment results from when the DTCs were last cleared up until they were checked. (Indicates the possibility of a malfunction when no DTCs are confirmed.)
Confirmed Shows the DTCs confirmed up to now. (The number of current trips differs for each DTC.)



f.

Check the details of the DTCs.

Click hereDrivetrain>K313F (MULTIDRIVE / CVT)>CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM>DIAGNOSTIC TROUBLE CODE CHART

NOTICE:

When simulating a symptom and using the GTS to check for DTCs, use normal mode. For DTCs in the Diagnostic Trouble Code Chart subject to "2 trip detection logic", perform the following:

Turn the ignition switch off after the symptom is simulated once. Then repeat the simulation process. When the symptom has been simulated twice, the MIL will illuminate and DTCs will be stored in the ECM.




CLEAR DTC (When Using GTS)


a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Powertrain / Transmission / Trouble Codes.

Powertrain > Transmission > Clear DTCs
50002 373

e.

Clear the DTCs.



CLEAR DTC (When not Using GTS)


a.

Perform either of the following operations:

NOTICE:

After turning ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


i.

Disconnect the cable from the negative (-) battery terminal for more than 1 minute.


ii.

Remove the EFI-MAIN NO. 1 and ETCS fuses from the No. 1 engine room relay block, located inside the engine compartment, for more than 1 minute.