Home › Drivetrain › EC69 (MANUAL TRANSMISSION / TRANSAXLE) › MANUAL TRANSAXLE SYSTEM › 2016.10–2019.09
RM32H0E _52 Drivetrain _060311 EC69 MANUAL TRANSMISSION / TRANSAXLE _0300017 MANUAL TRANSAXLE SYSTEM D

EC69 MANUAL TRANSMISSION / TRANSAXLE  MANUAL TRANSAXLE SYSTEM  DTC CHECK / CLEAR  


CHECK DTC (Using GTS)


a.

DTCs which are stored in the ECM can be output to the GTS.

i.

Connect the GTS to the DLC3.


ii.

Turn the ignition switch to ON.


iii.

Turn the GTS on.


iv.

Enter the following menus: Powertrain / Transmission / Trouble Codes.

Powertrain > Transmission > Trouble Codes
50001 373

v.

Confirm the DTCs and freeze frame data, and then write them down.





CLEAR DTC (Using GTS)


a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Powertrain / Transmission / Trouble Codes.


e.

Clear the DTCs.

Powertrain > Transmission > Clear DTCs
50002 373


CLEAR DTC (without Using GTS)


a.

Perform either of the following operations.

NOTICE:

After turning ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


i.

Disconnect the cable from the negative (-) battery terminal for more than 1 minute.


ii.

Remove the EFI-MAIN NO. 1 and ETCS fuses from the No. 1 engine room relay block located inside the engine compartment for more than 1 minute.