Home › Brake › BRAKE SYSTEM (OTHER) › VACUUM WARNING SWITCH (for RHD)
RM32H0E _54 Brake _060040 BRAKE SYSTEM (OTHER) _0300038 VACUUM WARNING SWITCH(for RHD) G

BRAKE SYSTEM (OTHER)  VACUUM WARNING SWITCH(for RHD)  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.INSPECT BRAKE FLUID LEVEL IN RESERVOIR

Hide 44610 2.INSPECT BRAKE BOOSTER ASSEMBLY

Hide 55701J 3.REMOVE OUTER COWL TOP PANEL SUB-ASSEMBLY

Hide 83390H 4.INSPECT VACUUM WARNING SWITCH ASSEMBLY

a.

Start the engine and stop it after 1 or 2 minutes.


b.

Disconnect the connector from the vacuum warning switch assembly.


c.

Measure the resistance of the vacuum warning switch assembly.

Standard Resistance:

10 kΩ or higher



d.

With the engine stopped, depress the brake pedal several times to release vacuum from the brake booster assembly, and measure the resistance of the vacuum warning switch assembly.

Standard Resistance:

Below 1 Ω



e.

Connect the connector to the vacuum warning switch assembly.


Hide 55701J 5.INSTALL OUTER COWL TOP PANEL SUB-ASSEMBLY