Home › Vehicle Exterior › LIGHTING (EXT) › LICENSE PLATE LIGHT BULB
RM32H0E _59 Vehicle Exterior _060313 LIGHTING (EXT) _0300237 LICENSE PLATE LIGHT BULB A

LIGHTING (EXT)  LICENSE PLATE LIGHT BULB  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1.REMOVE NO. 2 BACK DOOR SERVICE HOLE COVER

a.
E352416C01
1.99,0.792 2.417,1.25 true 2.469,1.26 2.677,1.469 0.208,0.208 10 true *a
*a Protective Tape
V113147

Remove in this Direction


Using a screw driver with its tip wrapped in protective tape, disengage the claws to remove the No. 2 back door service hole cover as shown in the illustration.


Hide 2.REMOVE LICENSE PLATE LIGHT BULB

a.
E352417C01
0,0 0,0 false
V113147

Remove in this Direction


Turn the license plate light socket and wire with the license plate light bulb as shown in the illustration to disconnect them as a unit.


b.
E352418C01
0,0 0,0 false
V113147

Remove in this Direction


Remove the license plate light bulb from the license plate light socket and wire as shown in the illustration.