Home › Drivetrain › CLUTCH › CLUTCH STROKE SENSOR (for RHD)
RM32H0E _52 Drivetrain _059611 CLUTCH _0292638 CLUTCH STROKE SENSOR(for RHD) G

CLUTCH  CLUTCH STROKE SENSOR(for RHD)  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 89280 1.INSPECT CLUTCH PEDAL STROKE SENSOR ASSEMBLY

a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Powertrain / Transmission / Data List / Clutch Stroke Sensor Voltage.

Powertrain > Transmission > Data List
Tester Display
Clutch Stroke Sensor Voltage
50003 373 607

e.

Read the values displayed on the GTS.

Standard Voltage:
GTS Display Condition Specified Condition
Clutch Stroke Sensor Voltage Clutch pedal fully released 0.96 to 1.04 V
Not depressed → Fully depressed (Clutch pedal should be operated slowly) Value changes progressively (Only increase)


If the result is not as specified, check the clutch pedal stroke sensor assembly, wire harness and ECM.