Home › Engine / Hybrid System › CRUISE CONTROL › CRUISE CONTROL SYSTEM (for 3ZR-FAE)
RM32H0E _51 Engine / Hybrid System _059516 CRUISE CONTROL _0300549 CRUISE CONTROL SYSTEM(for 3ZR-FAE) C

CRUISE CONTROL  CRUISE CONTROL SYSTEM(for 3ZR-FAE)  U0122  Lost Communication With Vehicle Dynamics Control Module  


DESCRIPTION

The ECM receives signals from the skid control ECU (brake actuator assembly) via CAN communication.

DTC No. Detection Item DTC Detection Condition Trouble Area
U0122 Lost Communication with Vehicle Dynamics Control Module While the vehicle speed is 40 km/h (25 mph) or more and the cruise control main switch (ON/OFF button) is on, signals cannot be received from the skid control ECU (brake actuator assembly) for 2.65 seconds or more.
·

CAN communication system

·

ECM

·

Skid control ECU (Brake actuator assembly)



CAUTION / NOTICE / HINT

HINT:

Refer to troubleshooting in CAN Communication System.

Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING


PROCEDURE

1.CHECK FOR DTCs (CRUISE CONTROL SYSTEM)
a.

Clear the DTCs.

Click hereEngine / Hybrid System>CRUISE CONTROL>CRUISE CONTROL SYSTEM (for 3ZR-FAE)>DTC CHECK / CLEAR

Powertrain > Cruise Control > Clear DTCs
50002 237

b.

Make sure that the DTC detection conditions are met.

HINT:

If the detection conditions are not met, the system cannot detect the malfunction.

1.

Drive the vehicle at a speed for which cruise control operation is possible.

2.

Turn the cruise control system on using the cruise control main switch (ON/OFF button).

3.

Push the cruise control main switch to -SET to begin control of vehicle speed using the cruise control system.




c.

Check for DTCs.

Click hereEngine / Hybrid System>CRUISE CONTROL>CRUISE CONTROL SYSTEM (for 3ZR-FAE)>DTC CHECK / CLEAR

Powertrain > Cruise Control > Trouble Codes
50001 237

Result:
Result Proceed to
DTC U0122 is not output A
DTC U0122 is output B



A

B