Home › Engine / Hybrid System › CRUISE CONTROL › CRUISE CONTROL SYSTEM (for 3ZR-FAE)
RM32H0E _51 Engine / Hybrid System _059516 CRUISE CONTROL _0300549 CRUISE CONTROL SYSTEM(for 3ZR-FAE) C

CRUISE CONTROL  CRUISE CONTROL SYSTEM(for 3ZR-FAE)  P0575  Cruise Control Input Circuit  


DESCRIPTION

This DTC is stored when there is a malfunction in the ECM.

DTC No. Detection Item DTC Detection Condition Trouble Area
P0575 Cruise Control Input Circuit While the cruise control system is operating, the cruise control system control of vehicle speed is not canceled and approximately 0.4 seconds have elapsed after cruise cancel signal (STP signal) is input to the ECM. ECM

CAUTION / NOTICE / HINT

NOTICE:

Before replacing the ECM, refer to Service Bulletin.


HINT:

The ECM receives signals from each sensor to control all functions of the cruise control system. When a malfunction is detected, the fail-safe function operates until the ignition switch off.


PROCEDURE

1.CHECK FOR DTCs (CRUISE CONTROL SYSTEM)
a.

Clear the DTCs.

Click hereEngine / Hybrid System>CRUISE CONTROL>CRUISE CONTROL SYSTEM (for 3ZR-FAE)>DTC CHECK / CLEAR

Powertrain > Cruise Control > Clear DTCs
50002 237

b.

Perform the following to make sure that the DTC detection conditions are met.

HINT:

If the detection conditions are not met, the malfunction cannot be detected.

1.

Drive the vehicle at a speed for which cruise control operation is possible.

2.

Turn the cruise control system on using the cruise control main switch (ON/OFF button).

3.

Push the cruise control main switch to -SET to begin control of vehicle speed using the cruise control system.

4.

Depress the brake pedal for 0.4 seconds or more.




c.

Check for DTCs.

Click hereEngine / Hybrid System>CRUISE CONTROL>CRUISE CONTROL SYSTEM (for 3ZR-FAE)>DTC CHECK / CLEAR

Powertrain > Cruise Control > Trouble Codes
50001 237
OK:

DTC P0575 is not output.



Result:
Proceed to
OK
NG



OK

NG