This DTC is stored when the clearance warning ECU assembly judges, as a result of its self check, that the voltage received by terminal IG is not normal.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1612 | IG Voltage is High | IG voltage is high | ·
Wire harness or connector ·
Clearance warning ECU assembly ·
Stop and start system*1 |
*1: w/ Stop and Start System
Inspect the fuses for circuits related to this system before performing the following procedure.
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization may be needed. Refer to Calibration.
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
Clear the DTCs.
Recheck for DTCs and check if the same DTC is output again.
No DTCs are output.
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
NG
Disconnect the F38 clearance warning ECU assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F38-1 (E) - Body ground | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the clearance warning ECU assembly connector.
| *a | Front view of wire harness connector
(to Clearance Warning ECU Assembly) |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F38-8 (IG) - F38-1 (E) | Ignition switch ON | 11 to 14 V*1
9.5 to 14 V*2 |
*1: w/o Stop and Start System
*2: w/ Stop and Start System
| Result | Proceed to |
|---|---|
| OK | A |
| NG (w/o Stop and Start System) | B |
| NG (w/ Stop and Start System) | C |
A
B
C
Click hereEngine / Hybrid System>STOP AND START>STOP AND START SYSTEM>Backup Boost Converter Circuit