Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › SIMPLE INTELLIGENT PARKING ASSIST SYSTEM › 2016.10–2019.09
RM32H0E _56 Audio / Visual / Telematics _060571 PARK ASSIST / MONITORING _0300931 SIMPLE INTELLIGENT PARKING ASSIST SYSTEM C

PARK ASSIST / MONITORING  SIMPLE INTELLIGENT PARKING ASSIST SYSTEM  U0073  Control Module Communication Bus "A" Off  U0100  Lost Communication with ECM / PCM "A"  U0126  Lost Communication with Steering Angle Sensor Module  U0129  Lost Communication with Brake System Control Module  U0131  Lost Communication with Power Steering Control Module  U0140  Lost Communication with Body Control Module  U0151  Lost Communication with Restraints Control Module (Air Bag)  U0155  Lost Communication With Instrument Panel Cluster (IPC) Control Module  U0164  Lost Communication with HVAC Control Module  U1103  Lost Communication with Stop and Start Control Module  


DESCRIPTION

These DTCs are stored if there is a malfunction in the CAN communication system connected to the clearance warning ECU assembly.

HINT:

If CAN communication system DTCs are stored, they may also be stored in other systems.


DTC No. Detection Item DTC Detection Condition Trouble Area
U0073 Control Module Communication Bus "A" Off Control module communication bus off CAN communication system
U0100 Lost Communication with ECM / PCM "A" Lost communication with ECM CAN communication system
U0126 Lost Communication with Steering Angle Sensor Module Lost communication with spiral cable with sensor sub-assembly CAN communication system
U0129 Lost Communication with Brake System Control Module Lost communication with brake actuator assembly (skid control ECU) CAN communication system
U0131 Lost Communication with Power Steering Control Module Lost communication with power steering ECU assembly CAN communication system
U0140 Lost Communication with Body Control Module Lost communication with main body ECU (multiplex network body ECU) CAN communication system
U0151 Lost Communication with Restraints Control Module (Air Bag) Lost communication with airbag sensor assembly CAN communication system
U0155 Lost Communication With Instrument Panel Cluster (IPC) Control Module Lost communication with combination meter assembly CAN communication system
U0164 Lost Communication with HVAC Control Module Lost communication with air conditioning amplifier assembly CAN communication system
U1103 Lost Communication with Stop and Start Control Module Lost communication with engine stop and start ECU* CAN communication system

*: w/ Stop and Start System


PROCEDURE

1.CHECK DTC OUTPUT
a.

Clear the DTCs.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>SIMPLE INTELLIGENT PARKING ASSIST SYSTEM>DTC CHECK / CLEAR

Body Electrical > IPA/ICS/Clearance Sonar > Clear DTCs
50002 170

b.

Recheck for DTCs and check if the same DTC is output again.

Body Electrical > IPA/ICS/Clearance Sonar > Trouble Codes
50001 170
OK:

No DTCs are output.


HINT:
·

If CAN communication system DTCs are stored, they may also be stored in other systems.

·

If the CAN communication system has been inspected and repaired in other systems, the DTCs will not be output when rechecking for DTCs.

·

If these DTCs are output frequently, duplicate the conditions that caused the problem symptoms and perform the inspection again, even though DTCs were not output when rechecking for DTCs.




Result:
Proceed to
OK
NG



OK

NG