Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
55405B
1.REMOVE INSTRUMENT CLUSTER FINISH CENTER PANEL SUB-ASSEMBLY
86120
2.REMOVE RADIO RECEIVER ASSEMBLY WITH BRACKET
Remove the 4 screws.
Pull the radio receiver assembly with bracket toward the rear of the vehicle to disengage the guides.
Disconnect each connector and remove the radio receiver assembly with bracket.
86211
3.REMOVE NO. 1 RADIO BRACKET
Remove the 3 screws and No. 1 radio bracket from the radio receiver assembly.
86212
4.REMOVE NO. 2 RADIO BRACKET
Remove the 3 screws and No. 2 radio bracket from the radio receiver assembly.