Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › TOYOTA PARKING ASSIST-SENSOR SYSTEM (w/o Simple Intelligent Parking Assist System) › 2016.10–2019.09
RM32H0E _56 Audio / Visual / Telematics _060571 PARK ASSIST / MONITORING _0298266 TOYOTA PARKING ASSIST-SENSOR SYSTEM(w/o Simple Intelligent Parking Assist System) C

PARK ASSIST / MONITORING  TOYOTA PARKING ASSIST-SENSOR SYSTEM(w/o Simple Intelligent Parking Assist System)  C164D  Wheel Speed Sensor Malfunction  


DESCRIPTION

This DTC is stored when the clearance warning ECU assembly receives a wheel speed sensor (front speed sensor RH or front speed sensor LH, rear speed sensor RH or rear speed sensor LH) abnormality signal from the Vehicle stability control system via CAN communication.

DTC No. Detection Item DTC Detection Condition Trouble Area
C164D Wheel Speed Sensor Malfunction Front wheel speed sensor malfunction Vehicle stability control system

PROCEDURE

1.CHECK DTC OUTPUT
a.

Using the GTS, check for DTCs according to the prompts on the screen.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>TOYOTA PARKING ASSIST-SENSOR SYSTEM (w/o Simple Intelligent Parking Assist System)>DTC CHECK / CLEAR

HINT:

After turning the ignition switch from off to ON, wait 4 seconds or more before checking for DTCs.


Body Electrical > IPA/ICS/Clearance Sonar > Trouble Codes
50001 170

b.

Clear the DTCs according to the screen on the GTS.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>TOYOTA PARKING ASSIST-SENSOR SYSTEM (w/o Simple Intelligent Parking Assist System)>DTC CHECK / CLEAR

Body Electrical > IPA/ICS/Clearance Sonar > Clear DTCs
50002 170

c.

Recheck for DTCs.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>TOYOTA PARKING ASSIST-SENSOR SYSTEM (w/o Simple Intelligent Parking Assist System)>DTC CHECK / CLEAR

Body Electrical > IPA/ICS/Clearance Sonar > Trouble Codes
50001 170
HINT:
·

DTC C164D is stored when a malfunction signal sent from the vehicle stability control system is detected.

·

If the malfunctioning part has been repaired or replaced before rechecking for DTCs, DTC C164D will not be output again.

·

If DTC C164D is output frequently, duplicate the conditions that cause the problem symptoms and perform the inspection again, even though the DTC was not output when rechecking for DTCs.

Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING



OK:

No DTCs are output



Result:
Result
OK
NG



OK

NG