Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › TOYOTA PARKING ASSIST-SENSOR SYSTEM (w/o Simple Intelligent Parking Assist System) › 2016.10–2019.09
RM32H0E _56 Audio / Visual / Telematics _060571 PARK ASSIST / MONITORING _0298266 TOYOTA PARKING ASSIST-SENSOR SYSTEM(w/o Simple Intelligent Parking Assist System) J

PARK ASSIST / MONITORING  TOYOTA PARKING ASSIST-SENSOR SYSTEM(w/o Simple Intelligent Parking Assist System)  Clearance Warning ECU Power Source Circuit  


DESCRIPTION

This circuit provides power to operate the clearance warning ECU assembly.

WIRING DIAGRAM

E361280E01
0.594,0.448 3.656,0.646 3.063,0.198 10 false from IG1-NO. 1 Relay 2.563,0.719 3.74,1.177 1.177,0.458 10 false ECU-IG1 NO. 4 5.25,0.333 5.406,0.531 0.156,0.198 10 false 8 5.25,1.094 5.406,1.292 0.156,0.198 10 false 1 5.479,0.438 5.719,0.646 0.24,0.208 10 false IG 5.458,1.208 5.698,1.417 0.24,0.208 10 false E 5.26,1.573 5.552,1.802 0.292,0.229 10 false F38 5.25,1.75 6.781,2.479 1.531,0.729 10 false Clearance Warning ECU Assembly

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following procedure.


PROCEDURE

1.CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU ASSEMBLY POWER SOURCE, BODY GROUND)
a.

Disconnect the clearance warning ECU assembly connector.


b.
E360127C01
1.5,0.188 1.938,0.469 0.438,0.281 0.781,1.583 1.177,1.198 true 2.781,1.625 2.271,1.177 true 1.594,0.24 2.052,0.438 0.458,0.198 10 false F38 0.698,1.625 1.156,1.823 0.458,0.198 10 false E 2.771,1.677 3.229,1.875 0.458,0.198 10 false IG 0.115,0.115 0.573,0.313 0.458,0.198 10 false *a
*a Front view of wire harness connector
(to Clearance Warning ECU Assembly)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
F38-1 (E) - Body ground Always Below 1 Ω



c.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
F38-8 (IG) - F38-1 (E) Ignition switch ON 11 to 14 V



Result:
Proceed to
OK
NG



OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR