Home › Engine / Hybrid System › CRUISE CONTROL › DRIVING SUPPORT BUZZER (for RHD)
RM32H0E _51 Engine / Hybrid System _059516 CRUISE CONTROL _0301151 DRIVING SUPPORT BUZZER(for RHD) G

CRUISE CONTROL  DRIVING SUPPORT BUZZER(for RHD)  INSPECTION  


PROCEDURE

Hide 86652E 1.INSPECT DRIVING SUPPORT BUZZER (PRE-COLLISION CITY BUZZER)

a.

Make sure that there is no looseness in the locking part and connecting part of the connector.


b.

Disconnect the driving support buzzer (pre-collision city buzzer) connector.


c.

Check the connector and terminals for deformation and corrosion.

OK:

No deformation or corrosion.



d.
A303614

Connect a positive (+) lead from the battery to terminal 1, and a negative (-) lead to terminal 2 of the driving support buzzer (pre-collision city buzzer), and check that the buzzer sounds.

OK:

The pre-collision city buzzer sounds.


If the result is not as specified, replace the driving support buzzer (pre-collision city buzzer).