Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › TOYOTA PARKING ASSIST-SENSOR SYSTEM (w/o Simple Intelligent Parking Assist System) › 2016.10–2019.09
RM32H0E _56 Audio / Visual / Telematics _060571 PARK ASSIST / MONITORING _0298266 TOYOTA PARKING ASSIST-SENSOR SYSTEM(w/o Simple Intelligent Parking Assist System) D

PARK ASSIST / MONITORING  TOYOTA PARKING ASSIST-SENSOR SYSTEM(w/o Simple Intelligent Parking Assist System)  CALIBRATION  


NOTICE:

When the clearance warning ECU assembly have been replaced, be sure to perform Clearance Sonar Detection/Steering Adjustment. If not, the TOYOTA parking assist-sensor system may not operate correctly.


BUMPER TYPE REGISTRATION


a.

Preparation

i.

Confirm that the following DTCs are not output.

System Proceed to
TOYOTA Parking Assist-sensor System (Click here)



b.

Connect the GTS to the DLC3.


c.

Turn the ignition switch ON.


d.

Turn the GTS on.


e.

Enter the following menus: Body Electrical / IPA/ICS/Clearance Sonar / Utility.

Body Electrical > IPA/ICS/Clearance Sonar > Utility
Tester Display
Clearance Sonar Detection/Steering Adjustment
50005 170 4402

f.

According to the display on the GTS, perform calibration.

NOTICE:

Do not select "Battery or Steering Sensor" because doing so will make bumper type registration impossible.



g.

Enter the bumper type using the GTS.

Bumper Type Value
Standard 1

HINT:

If the clearance warning ECU assembly is replaced, it is necessary to perform bumper type registration.



h.

Disconnect the GTS from the DLC3.