Home › Vehicle Exterior › LIGHTING (EXT) › AUTOMATIC HIGH BEAM SYSTEM › 2016.10–2020.08
RM32H0E _59 Vehicle Exterior _060313 LIGHTING (EXT) _0303031 AUTOMATIC HIGH BEAM SYSTEM L

LIGHTING (EXT)  AUTOMATIC HIGH BEAM SYSTEM  PRECAUTION  


IGNITION SWITCH EXPRESSIONS


a.

The type of ignition switch used on this model differs depending on the specifications of the vehicle. The expressions listed in the table below are used in this section.

Expression Ignition Switch (Position) Engine Switch (Condition)
Ignition Switch off LOCK Off (Lock)
Ignition Switch ACC ACC On (ACC)
Ignition Switch ON ON On (IG)
Engine Start START On (Start)



HANDLING PRECAUTIONS FOR FORWARD RECOGNITION CAMERA


a.

The automatic high beam system uses the forward recognition camera. For precautions related to the forward recognition camera, refer to Precaution for Forward Recognition Camera System.

Click hereEngine / Hybrid System>CRUISE CONTROL>FRONT CAMERA>ADJUSTMENT (SEQUENTIAL RECOGNITION)



PRECAUTION WHEN REPLACING COMBINATION METER ASSEMBLY


a.

When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.