Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › SIMPLE INTELLIGENT PARKING ASSIST SYSTEM › 2016.10–2019.09
RM32H0E _56 Audio / Visual / Telematics _060571 PARK ASSIST / MONITORING _0300931 SIMPLE INTELLIGENT PARKING ASSIST SYSTEM C

PARK ASSIST / MONITORING  SIMPLE INTELLIGENT PARKING ASSIST SYSTEM  C1AEA  Steering Angle Midpoint Initial Setting Incomplete  


DESCRIPTION

When the clearance warning ECU assembly detects that the steering angle neutral point memorization is incomplete during self diagnosis, C1AEA is stored.

DTC No. Detection Item DTC Detection Condition Trouble Area
C1AEA Steering Angle Midpoint Initial Setting Incomplete Steering angle neutral point memorization incomplete
·

Steering sensor steering angle neutral point memorization incomplete

·

Clearance warning ECU assembly



CAUTION / NOTICE / HINT

NOTICE:
·

If DTCs are output after repairs, turn the ignition switch ON and the TOYOTA parking assist-sensor system on. Then clear the DTCs.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>SIMPLE INTELLIGENT PARKING ASSIST SYSTEM>DTC CHECK / CLEAR

·

Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization may be needed. Refer to Calibration.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>SIMPLE INTELLIGENT PARKING ASSIST SYSTEM>CALIBRATION



PROCEDURE

1.PERFORM CALIBRATION

Result:
Proceed to
NEXT



NEXT

2.CHECK FOR DTC
2.CHECK FOR DTC
a.

Using the GTS, check for DTCs according to the prompts on the screen.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>SIMPLE INTELLIGENT PARKING ASSIST SYSTEM>DTC CHECK / CLEAR

Body Electrical > IPA/ICS/Clearance Sonar > Trouble Codes
50001 170

b.

Clear the DTCs according to the screen on the GTS.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>SIMPLE INTELLIGENT PARKING ASSIST SYSTEM>DTC CHECK / CLEAR

Body Electrical > IPA/ICS/Clearance Sonar > Clear DTCs
50002 170

c.

Recheck for DTCs.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>SIMPLE INTELLIGENT PARKING ASSIST SYSTEM>DTC CHECK / CLEAR

Body Electrical > IPA/ICS/Clearance Sonar > Trouble Codes
50001 170
HINT:
·

If DTC C1AEA is output, perform steering angle neutral point memorization.

·

If DTC C1AEA is still output after performing steering angle neutral point memorization 3 times, replace the clearance warning ECU assembly.



OK:

No DTCs are output.



Result:
Proceed to
OK
NG



OK

NG