Home › Drivetrain › EC69 (MANUAL TRANSMISSION / TRANSAXLE) › SPEED SENSOR › 2016.10–2019.09
RM32H0E _52 Drivetrain _060311 EC69 MANUAL TRANSMISSION / TRANSAXLE _0303339 SPEED SENSOR G

EC69 MANUAL TRANSMISSION / TRANSAXLE  SPEED SENSOR  INSPECTION  


PROCEDURE

Hide 89413B 1.INSPECT TRANSMISSION REVOLUTION SENSOR

a.

Connect the battery to the sensor as shown in the illustration.

C277851C20
1.333,1.958 1.594,1.469 true 4.521,1.156 4.229,0.979 true 3.667,1.146 3.948,0.969 true 2.063,1.948 1.802,1.469 true 6.115,1.24 5.813,1.01 true 4.906,0.844 4.813,0.552 true 4.698,2.563 4.927,2.302 false 6.135,1.677 5.448,2.146 true 4.969,0.781 5.281,0.938 0.313,0.156 10 false *d 6.198,1.188 6.51,1.385 0.313,0.198 10 false *1 1,0.563 1.313,0.719 0.313,0.156 10 false *a 4.49,2.479 4.802,2.635 0.313,0.156 10 false *c 1.135,2.01 1.583,2.219 0.448,0.208 10 false NCO+ 1.979,2.01 2.438,2.219 0.458,0.208 10 false NCO- 4.583,1.094 4.771,1.292 0.188,0.198 10 false 1 3.552,1.083 3.74,1.281 0.188,0.198 10 false 2 6.198,1.615 6.51,1.813 0.313,0.198 10 false *b
*1 Battery - -
*a Component without harness connected
(Transmission Revolution Sensor)
*b Magnet
*c 5 mm or less *d Ammeter



b.

Wave a magnetic object left and right in front of the transmission revolution sensor tip (5 mm (0.197 in.) or less) to change the high/low signals while measuring the current.

NOTICE:

Make sure to wave the magnetic object during the inspection. The current will not change without waving the magnetic object as indicated by the arrow in the illustration.



c.

Measure the current according to the value(s) in the table below.

Standard Current:
Tester Connection Condition Specified Condition
1 (NCO-) - 2 (NCO+) Low signal 4 to 8 mA
1 (NCO-) - 2 (NCO+) High signal 12 to 16 mA