Home › Drivetrain › EC69 (MANUAL TRANSMISSION / TRANSAXLE) › INTELLIGENT MANUAL TRANSMISSION SWITCH › 2016.10–2019.09
RM32H0E _52 Drivetrain _060311 EC69 MANUAL TRANSMISSION / TRANSAXLE _0303344 INTELLIGENT MANUAL TRANSMISSION SWITCH G

EC69 MANUAL TRANSMISSION / TRANSAXLE  INTELLIGENT MANUAL TRANSMISSION SWITCH  INSPECTION  


PROCEDURE

Hide 84720J 1.INSPECT PATTERN SELECT SWITCH ASSEMBLY (INTELLIGENT MANUAL TRANSMISSION SWITCH)

a.

Check the resistance.

i.
C369025C02
2.031,1.052 2.448,0.635 true 1.396,1.052 0.979,0.635 true 0.115,0.104 0.427,0.302 0.313,0.198 10 false *a 0.771,0.552 1.083,0.75 0.313,0.198 10 false IG 2.5,0.542 2.813,0.74 0.313,0.198 10 false GND
*a Component without harness connected
(Pattern Select Switch Assembly (Intelligent Manual Transmission Switch))


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
4 (IG) - 1 (GND) Switch pushed Below 1 Ω
4 (IG) - 1 (GND) Switch not pushed 10 kΩ or higher


If the result is not as specified, replace the pattern select switch assembly (intelligent manual transmission switch).



b.

Check that the illumination illuminates.

i.
C369025C01
1.823,1.052 2.313,0.521 true 1.615,1.042 1.125,0.521 true 0.094,0.094 0.406,0.292 0.313,0.198 10 false *a 2.365,0.438 2.979,0.635 0.615,0.198 10 false ILL- 0.802,0.427 1.417,0.625 0.615,0.198 10 false ILL+
*a Component without harness connected
(Pattern Select Switch Assembly (Intelligent Manual Transmission Switch))


Apply battery voltage between the terminals of the switch, and check the illumination condition of the pattern select switch assembly (intelligent manual transmission switch).

Standard:
Measurement Condition Specified Condition
Battery positive (+) → 3 (ILL+) Battery negative (-) → 2 (ILL-) Illuminates


If the result is not as specified, replace the pattern select switch assembly (intelligent manual transmission switch).