The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced the during antenna cord sub-assembly removal/installation are shown below.
*1: When performing learning using the GTS.
*2: w/ Stop and start system
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
55401E
1.REMOVE INSTRUMENT PANEL SAFETY PAD
55086
2.REMOVE NO. 3 HEATER TO REGISTER DUCT SUB-ASSEMBLY (for LHD)
55084E
3.REMOVE NO. 1 HEATER TO REGISTER DUCT SUB-ASSEMBLY (for RHD)
86101
4.REMOVE ANTENNA CORD SUB-ASSEMBLY (for LHD)
Disengage the clamps to remove the antenna cord sub-assembly.
Disconnect the connector.
86101
5.REMOVE ANTENNA CORD SUB-ASSEMBLY (for RHD)
Disengage the clamps to remove the antenna cord sub-assembly.
Disconnect the connector.
63311C
6.REMOVE ROOF HEADLINING
86101J
7.REMOVE NO. 2 ANTENNA CORD SUB-ASSEMBLY
Type A:
Remove each adhesive tape from the roof headlining.
| *A | w/ Digital Audio Broadcasting Antenna | - | - |
| *a | Notch | *b | Clamp |
|
Adhesive Tape |
|
Front |
Disengage the clamp and notch to remove the No. 2 antenna cord sub-assembly from the roof headlining.
Type B:
Remove each adhesive tape from the roof headlining.
| *A | w/ Digital Audio Broadcasting Antenna | - | - |
| *a | Notch | *b | Clamp |
|
Adhesive Tape |
|
Front |
Disengage the clamp and notch to remove the No. 2 antenna cord sub-assembly from the roof headlining.
86101R
8.REMOVE NO. 5 ANTENNA CORD SUB-ASSEMBLY (w/ Digital Audio Broadcasting Antenna)
Disconnect the connector.
Disengage the clamp to remove the No. 5 antenna cord sub-assembly.
86101D
9.REMOVE NO. 3 ANTENNA CORD SUB-ASSEMBLY
w/o FM Sub-antenna:
Disconnect the connector.
Disengage the clamps.
| *a | Guide |
| *b | Clamp |
Remove the bolt.
Disengage the clamp and guide to remove the No. 3 antenna cord sub-assembly.
w/ FM Sub-antenna:
Disconnect the connector of the No. 4 antenna cord sub-assembly.
Disconnect the connector.
Disengage the clamps.
| *a | Guide |
| *b | Clamp |
Disconnect the connector of the floor wire.
Remove the bolt.
Disengage the clamp and guide to remove the No. 3 antenna cord sub-assembly.
64790B
10.REMOVE BACK DOOR TRIM UPPER PANEL ASSEMBLY (w/ FM Sub-antenna)
86101Q
11.REMOVE NO. 4 ANTENNA CORD SUB-ASSEMBLY (w/ FM Sub-antenna)
Disconnect the connector.
Disengage the clamp and 2 grommets to remove the No. 4 antenna cord sub-assembly.