Home › General › MAINTENANCE › REAR DISC BRAKE PAD › 2016.10–2018.05
RM32H0E _V1 General _059503 MAINTENANCE _0304825 REAR DISC BRAKE PAD A

MAINTENANCE  REAR DISC BRAKE PAD  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

The following procedure is for the LH side.

·

Use the same procedure for the RH side and LH side.



PROCEDURE

Hide 1.REMOVE REAR WHEEL

Hide 2.DRAIN BRAKE FLUID

NOTICE:

If brake fluid leaks onto any painted surface, immediately wash it off.


Hide 04466 3.REMOVE REAR DISC BRAKE PAD

CAUTION:
·
C368019

After lifting up the rear disc brake cylinder assembly, secure it in place before performing any work on it.

·

The rear disc brake cylinder assembly could fall, pinching hands or fingers and causing injury.



a.
C368443

Disconnect the No. 2 parking brake wire assembly connector from the parking brake actuator assembly.


b.
C368444C01
2.802,2.219 3.115,2.417 0.313,0.198 10 false *a 2.479,0.885 2.792,1.083 0.313,0.198 10 false *b
*a Hold
*b Turn


Hold the rear disc brake cylinder slide pin, and remove the bolt.


c.
C368445

Pull the rear disc brake cylinder assembly upward.


d.

Remove the 2 rear disc brake pads from the rear disc brake cylinder mounting.


Hide 04946 4.REMOVE REAR DISC BRAKE ANTI-SQUEAL SHIM KIT

a.

Remove the rear No. 1 disc brake anti-squeal shim and rear No. 2 disc brake anti-squeal shim from each rear disc brake pad.


b.
C366017

Using a screwdriver, remove the rear disc brake pad wear indicator plate from each rear disc brake pad.