Home › General › MAINTENANCE › REAR DISC BRAKE PAD (for TMMT Made) › from 2018.05
RM32H0E _V1 General _059503 MAINTENANCE _0358315 REAR DISC BRAKE PAD(for TMMT Made) A

MAINTENANCE  REAR DISC BRAKE PAD(for TMMT Made)  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

The following procedure is for the LH side.

·

Use the same procedure for the RH side and LH side.



PROCEDURE

Hide 2.REMOVE REAR WHEEL

Hide 3.PERFORM REAR BRAKE PAD REPLACEMENT MODE

Hide 4.DRAIN BRAKE FLUID

NOTICE:

If brake fluid leaks onto any painted surface, immediately wash it off.


Hide 04466 5.REMOVE REAR DISC BRAKE PAD

CAUTION:
·
C368019

After lifting up the rear disc brake cylinder assembly, secure it in place before performing any work on it.

·

The rear disc brake cylinder assembly could fall, pinching hands or fingers and causing injury.



a.
C399528

Disconnect the No. 2 parking brake wire assembly connector from the parking brake actuator assembly.


b.
C399529C01
2.75,2.177 3.063,2.333 0.313,0.156 10 false *a 2.427,0.802 2.74,0.958 0.313,0.156 10 false *b
*a Hold
*b Turn


Hold the rear disc brake cylinder slide pin, and remove the bolt.


c.
C399530

Pull the rear disc brake cylinder assembly upward.


d.

Remove the 2 rear disc brake pads from the rear disc brake cylinder mounting.


Hide 04946 6.REMOVE REAR DISC BRAKE ANTI-SQUEAL SHIM KIT

a.

Remove the rear disc brake anti-squeal shim from each rear disc brake pad.