Home › Engine / Hybrid System › 8NR-FTS (EMISSION CONTROL) › DIFFERENTIAL PRESSURE SENSOR › from 2018.05
RM32H0E _51 Engine / Hybrid System _060038 8NR-FTS EMISSION CONTROL _0359845 DIFFERENTIAL PRESSURE SENSOR G

8NR-FTS EMISSION CONTROL  DIFFERENTIAL PRESSURE SENSOR  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 89481B 1.INSPECT DIFFERENTIAL PRESSURE SENSOR

a.
A426788E01
2.458,1.427 2.125,0.865 true 2.385,1.458 2.74,1.698 0.354,0.24 10 true SST

Connect the GTS to the DLC3.


b.

Turn the engine switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus: Powertrain / Engine and ECT / Data List / GPF Differential Pressure Offset Bank 1.

Powertrain > Engine > Data List
Tester Display
GPF Differential Pressure Offset Bank1
50003 372 811

e.

Slide the clip and disconnect the vacuum transmitting hose from the differential pressure sensor.


f.

Connect SST to the differential pressure sensor.


g.

Using SST, apply pressure to the differential pressure sensor.

SST
09992-00242  


h.

Check the pressure value of the differential pressure sensor.

Standard:
GTS Display Condition Specified Condition
GPF Differential Pressure Offset Bank 1 Engine switch on (IG) When applying 20 kPa (2.9 psi): 20 kPa (2.9 psi)
When applying 40 kPa (5.8 psi): 40 kPa (5.8 psi)


NOTICE:

Perform the inspection within the range of 0 to 98 kPa (0 to 1 kg/cm2, 0 to 14.2 psi).


If the result is not as specified, check the differential pressure sensor circuit.


i.

Disconnect SST from the differential pressure sensor.


j.

Connect the vacuum transmitting hose to the differential pressure sensor and slide the clip to secure the hose.