Home › Engine / Hybrid System › 8NR-FTS (EMISSION CONTROL) › DIFFERENTIAL PRESSURE SENSOR › from 2018.05
RM32H0E _51 Engine / Hybrid System _060038 8NR-FTS EMISSION CONTROL _0359845 DIFFERENTIAL PRESSURE SENSOR A

8NR-FTS EMISSION CONTROL  DIFFERENTIAL PRESSURE SENSOR  INSTALLATION  


PROCEDURE

Hide 89481B 1.INSTALL DIFFERENTIAL PRESSURE SENSOR

a.

Install the differential pressure sensor to the inlet No. 1 air duct sub-assembly with the bolt.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


b.

Connect the vacuum transmitting hose to the differential pressure sensor and slide the clip to secure it.


c.

Connect the differential pressure sensor connector.


Hide 89481B 2.LEARNING DIFFERENTIAL PRESSURE SENSOR

a.

Start the engine and allow it to idle until the engine coolant temperature reaches 75°C (167°F) or higher (A).


b.

Turn the engine switch off and wait for 30 seconds or more (B).


c.

Repeat the above procedures (A) and (B) 3 times.

HINT:

Procedures (A) and (B) must be repeated 3 times to complete the differential pressure sensor learning process.