Home › Vehicle Interior › PRE-COLLISION › PRE-COLLISION SYSTEM › 2018.05–2019.09
RM32H0E _58 Vehicle Interior _059622 PRE-COLLISION _0298842 PRE-COLLISION SYSTEM D

PRE-COLLISION  PRE-COLLISION SYSTEM  DIAGNOSIS SYSTEM  



FUNCTION OF WARNING INDICATOR AND MESSAGE


a.

If the pre-collision system is not functioning properly, the driver is warned by the PCS warning light and a warning message displayed on the multi-information display.

Master Warning Indicator*2 Warning Message Detail DTC PCS warning light
Illuminated "Pre-Collision System Malfunction Visit Your Dealer"*1 Pre-collision system malfunctioning Stored Blinks
"PRE-COLLISION SYSTEM MALFUNCTION VISIT YOUR DEALER"*2
Not illuminated "Pre-Collision System Unavailable"*1 Millimeter wave radar sensor assembly misaligned Not stored Illuminated
"PRE-COLLISION SYSTEM UNAVAILABLE"*2
Not illuminated "Pre-Collision System Unavailable Clean Sensor"*1 Foreign matter attached to millimeter wave radar sensor assembly Not stored Illuminated
"PRE-COLLISION SYSTEM UNAVAILABLE CLEAN SENSOR"*2
Not illuminated "Front Camera Unavailable"*1
·

Abnormal forward recognition camera voltage

·

Forward recognition camera temperature outside of operational range


Not stored Illuminates
"FRONT CAMERA UNAVAILABLE"*2
Not illuminated "Front Camera Vision Blocked. Clean and Demist Windshield"*1 Foreign matter attached to forward recognition camera or area of windshield in front of forward recognition camera Not stored Illuminates
"FRONT CAMERA VISION BLOCKED CLEAN AND DEMIST WINDSHIELD"*2
Not illuminated "VSC Turned Off Pre-Collision Brake System Unavailable"*1 VSC system is disabled Not stored Illuminates
"VSC TURNED OFF PRE-COLLISION BRAKE SYSTEM UNAVAILABLE"*2

*1: for Color TFT Type

*2: for Monochrome TFT Type


HINT:
PCS Warning Light Illumination Status
PCS Warning Light Condition
Blinks ON: 0.5 sec./OFF: 1.5 sec. Pre-collision system malfunctioning (DTC stored)
Illuminated Pre-collision system temporarily disabled
Pre-collision system disabled
VSC system disabled
Not illuminated Other




INITIAL CHECK


a.

An initial check is performed when the ignition switch is off for more than 2 seconds and then turned ON. The initial check consists of a pre-collision system diagnostic check with a duration of approximately 3 seconds.


b.

If a malfunction is detected during the initial check, the PCS warning light in the combination meter assembly will blink and a warning message indicating the pre-collision system is malfunctioning or disabled will be displayed on the multi-information display.



CONSTANT CHECK


a.

The millimeter wave radar sensor assembly constantly monitors the pre-collision system for malfunctions after the ignition switch is turned to ON and the initial check (approximately 3 seconds) has completed.


b.

If a malfunction is detected during the constant check, the PCS warning light in the combination meter assembly will blink and a warning message indicating the pre-collision system is malfunctioning or disabled will be displayed on the multi-information display.