Home › General › SPECIFICATIONS › 8NR-FTS ENGINE CONTROL › from 2018.05
RM32H0E _V1 General _059376 SPECIFICATIONS _0295134 8NR-FTS ENGINE CONTROL F

SPECIFICATIONS  8NR-FTS ENGINE CONTROL  SERVICE DATA  


IGNITION SYSTEM
Standard Insulation Resistance Spark plug (terminal part) - Body ground 10 MΩ or higher
Spark Plug Type NGK made DILKAR8J9G
Maximum Electrode Gap for Used Spark Plug 1.1 mm (0.0433 in.)
Standard Electrode Gap for New Spark Plug 0.8 to 0.9 mm (0.0315 to 0.0354 in.)

CAMSHAFT OIL CONTROL VALVE (for Intake Side)
Standard Stroke 4.5 mm (0.177 in.) or more

CAMSHAFT OIL CONTROL VALVE (for Exhaust Side)
Standard Stroke 2.2 mm (0.0866 in.) or more

CAMSHAFT OIL CONTROL SOLENOID
Standard Resistance 1 - 2 0 °C (32 °F) 5.3 to 6.3 Ω
20 °C (68 °F) 5.8 to 6.8 Ω
40 °C (104 °F) 6.2 to 7.4 Ω
Stroke Amount Standard 6.5 mm (0.256 in.) or more

THROTTLE BODY
Standard Resistance 1 (M-) - 2 (M+) 20°C (68°F) 0.3 to 100 Ω

ACCELERATOR PEDAL
Standard Voltage Accelerator Position Sensor No.1 Voltage Accelerator pedal fully released 0.5 to 1.1 V
Accelerator pedal fully depressed 2.6 to 4.5 V
Accelerator Position Sensor No.2 Voltage Accelerator pedal fully released 1.2 to 2.0 V
Accelerator pedal fully depressed 3.4 to 4.75 V

MASS AIR FLOW METER
Standard Resistance 4 (THA) - 5 (E2) 0.48 to 17.7 kΩ

ENGINE COOLANT TEMPERATURE SENSOR
Standard Resistance 20°C (68°F) 2.32 to 2.59 kΩ
80°C (176°F) 0.310 to 0.326 kΩ

ENGINE OIL TEMPERATURE SENSOR
Standard Resistance 30°C (86°F) 2.647 to 3.021 kΩ

KNOCK SENSOR
Standard Resistance 25°C (77°F) 120 to 280 kΩ

MANIFOLD ABSOLUTE PRESSURE SENSOR
Standard Voltage
(No. 1 turbo pressure sensor)
B192-3 (VC) - B192-2 (E2) IG ON 4.75 to 5.25 V
B192-1 (PIM) - B192-2 (E2) 3.0 to 5.25 V
Standard Resistance
(No. 2 turbo pressure sensor)
4 (THIM) - 2 (E2) -20°C (-4°F) 13.8 to 18.6 kΩ
20°C (68°F) 2.09 to 2.81 kΩ
80°C (176°F) 0.274 to 0.370 kΩ

AIR FUEL RATIO SENSOR (w/o Differential Pressure Sensor)
Standard Resistance 1 (HA1A) - 2 (+B) 20°C (68°F) 1.6 to 3.2 Ω
1 (HA1A) - 4 (A1A-) Always 10 kΩ or higher

AIR FUEL RATIO SENSOR (Sensor 1) (w/ Differential Pressure Sensor)
Standard Resistance 1 (HA1A) - 2 (+B) 20°C (68°F) 1.6 to 3.2 Ω
1 (HA1A) - 4 (A1A-) Always 10 kΩ or higher

AIR FUEL RATIO SENSOR (Sensor 2) (w/ Differential Pressure Sensor)
Standard Resistance 1 (HA1B) - 2 (+B) 20°C (68°F) 2 to 6 Ω
1 (HA1B) - 4 (A1B-) Always 10 kΩ or higher

HEATED OXYGEN SENSOR (w/o Differential Pressure Sensor)
Standard Resistance 1 (HT1B) - 2 (+B) 20°C (68°F) 5 to 10 Ω
1 (HT1B) - 4 (E2) Always 10 kΩ or higher

RELAY
Standard Resistance
(EFI Main Relay (EFI MAIN))
3-5 Battery voltage not applied between terminals 1 and 2 10 kΩ or higher
Battery voltage applied between terminals 1 and 2 Below 1 Ω
Standard Resistance
(No. 2 EFI Main Relay (EFI MAIN NO. 2))
3-5 Battery voltage not applied between terminals 1 and 2 10 kΩ or higher
Battery voltage applied between terminals 1 and 2 Below 1 Ω
Standard Resistance
(EFI Injection Relay (D INJ))
3-5 Battery voltage not applied between terminals 1 and 2 10 kΩ or higher
Battery voltage applied between terminals 1 and 2 Below 1 Ω