Home › Engine / Hybrid System › 8NR-FTS (STARTING) › STARTER (for Valeo Made except Cold Area Specification Vehicles)
RM32H0E _51 Engine / Hybrid System _060199 8NR-FTS STARTING _0295155 STARTER(for Valeo Made except Cold Area Specification Vehicles) A

8NR-FTS STARTING  STARTER(for Valeo Made except Cold Area Specification Vehicles)  DISASSEMBLY  


PROCEDURE

Hide 28150 1.REMOVE MAGNET STARTER SWITCH ASSEMBLY

a.
A444804

Remove the nut to disconnect the lead wire from the terminal C.


b.
A444805

Using a T20 "TORX" socket wrench, remove the 2 screws.


c.
A444806

Remove the magnet starter switch assembly.


Hide 28120 2.REMOVE STARTER YOKE ASSEMBLY

a.
A444807

Remove the 2 through bolts and pull out the starter yoke assembly together with starter commutator end frame assembly.


Hide 28130 3.REMOVE STARTER COMMUTATOR END FRAME ASSEMBLY

a.
A444808

Remove the starter commutator end frame assembly from the starter yoke assembly.


Hide 28160 4.REMOVE STARTER ARMATURE ASSEMBLY

a.
A444819

Remove the starter armature assembly from the starter yoke assembly.


Hide 28021 5.REMOVE STARTER CENTER BEARING CLUTCH SUB-ASSEMBLY

a.
A444810C01
2.563,0.375 2.271,0.542 false 2.49,1.083 2.219,1.271 false 1.583,1.76 1.344,1.875 false 0.656,1.396 0.458,1.656 false 1.177,1.802 1.49,1.958 0.313,0.156 10 false *1 0.281,1.594 0.594,1.75 0.313,0.156 10 false *2 2.615,0.281 2.833,0.469 0.219,0.188 10 false *3 2.542,0.99 2.854,1.146 0.313,0.156 10 false *4
*1 Starter Center Bearing Clutch Sub-assembly
*2 Starter Drive Housing Assembly
*3 Pinion Drive Lever
*4 Plastic Seal


Remove the starter center bearing clutch sub-assembly together with the pinion drive lever and plastic seal from the starter drive housing assembly.