Home › Engine / Hybrid System › 8NR-FTS (STARTING) › STARTER (for Valeo Made Cold Area Specification Vehicles)
RM32H0E _51 Engine / Hybrid System _060199 8NR-FTS STARTING _0295159 STARTER(for Valeo Made Cold Area Specification Vehicles) A

8NR-FTS STARTING  STARTER(for Valeo Made Cold Area Specification Vehicles)  DISASSEMBLY  


PROCEDURE

Hide 1.REMOVE MAGNET STARTER SWITCH ASSEMBLY

a.
A444859

Remove the nut to disconnect the lead wire from the terminal C.


b.
A444860

Using a T20 "TORX" socket wrench, remove the 2 screws and magnet starter switch assembly from the starter drive housing assembly.


Hide 2.REMOVE STARTER YOKE ASSEMBLY

a.
A444861

Remove the 2 through bolts and pull out the starter yoke assembly together with starter commutator end frame assembly.


Hide 28021 3.REMOVE STARTER CENTER BEARING CLUTCH SUB-ASSEMBLY

a.
A379538

Remove the rubber seal from the starter drive housing.


b.
A444864

Remove the starter center bearing clutch sub-assembly together with the pinion drive lever from the starter drive housing assembly.