Home › Engine / Hybrid System › 8NR-FTS (STARTING) › STARTER (for Valeo Made Cold Area Specification Vehicles)
RM32H0E _51 Engine / Hybrid System _060199 8NR-FTS STARTING _0295159 STARTER(for Valeo Made Cold Area Specification Vehicles) A

8NR-FTS STARTING  STARTER(for Valeo Made Cold Area Specification Vehicles)  REASSEMBLY  


PROCEDURE

Hide 28021 1.INSTALL STARTER CENTER BEARING CLUTCH SUB-ASSEMBLY

a.
A444870C01
0,0 0,0 false
V100135

High-temperature Grease


Apply high-temperature grease to the drive lever contact surfaces.

HINT:

Apply approximately 0.1 g of high-temperature grease to each section.



b.
A444864

Install the starter center bearing clutch sub-assembly together with the starter drive lever to the starter drive housing assembly.


Hide 2.INSTALL STARTER YOKE ASSEMBLY

a.
A444873C01
1.698,1.281 2.385,0.208 true 1.104,1.74 1.594,1.26 true 0.917,1.656 1.229,1.854 0.313,0.198 10 false *a 2.427,0.104 2.74,0.302 0.313,0.198 10 false *b
*a Protrusion
*b Cutout


Align the cutout of the starter yoke assembly with the protrusion of the starter drive housing assembly.


b.
A444861

Install the starter yoke assembly with the 2 through bolts.

Torque:
7.0 N*m (71 kgf*cm, 62 in.*lbf)


Hide 3.INSTALL MAGNET STARTER SWITCH ASSEMBLY

a.
A446760C01
0,0 0,0 false
V100135

High-temperature Grease


Apply high-temperature grease to the pinion drive lever.

HINT:

Apply a total of approximately 0.3 g (0.0105 oz) of high-temperature grease to the pinion drive lever.



b.
A444860

Using a T20 "TORX" socket wrench, Install the magnet starter switch assembly with the 2 bolts.

Torque:
3.6 N*m (37 kgf*cm, 32 in.*lbf)


c.
A444859

Connect the lead wire to terminal C with the nut.

Torque:
9.5 N*m (97 kgf*cm, 84 in.*lbf)