Home › Vehicle Interior › INTERIOR PANELS / TRIM › ROOF HEADLINING › from 2019.09
RM32H0E _58 Vehicle Interior _059856 INTERIOR PANELS / TRIM _0293792 ROOF HEADLINING A

INTERIOR PANELS / TRIM  ROOF HEADLINING  DISASSEMBLY  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for LHD and RHD vehicles.

·

The procedure listed below is for the LHD vehicles.



PROCEDURE

Hide 63343 1.REMOVE NO. 3 ROOF SILENCER PAD (w/ No.3 roof silencer pad)

a.

Remove the 2 No. 3 roof silencer pads.

B461369


Hide 63341 2.REMOVE NO. 1 ROOF SILENCER PAD (w/ No.1 roof silencer pad)

a.

Remove the No. 1 roof silencer pad.

B461375


Hide 63387 3.REMOVE ROOF HEADLINING FORMING PAD

a.

Remove the 2 roof headlining forming pads.

B461444


Hide 63342 4.REMOVE NO. 2 ROOF SILENCER PAD

a.

Remove the 2 No. 2 roof silencer pads.

B461377


Hide 63341G 5.REMOVE ROOF SILENCER PAD

a.

Remove the 2 roof silencer pads.

B461379


Hide 82171 6.REMOVE NO. 1 ROOF WIRE

a.

for TMMT Made:

B557960C01
3.365,0.313 5.781,1.396 2.417,1.083 4.625,0.313 4.625,1.396 false 5.333,0.833 5.5,0.583 true 0.635,1.063 0.333,1 true 1,2.417 0.833,2.333 true 0.167,0.156 0.521,0.427 0.354,0.271 12 false *A 0.167,1.417 0.49,1.625 0.323,0.208 12 false *B 3.396,0.344 3.719,0.583 0.323,0.24 12 false *C 4.656,0.344 4.969,0.563 0.313,0.219 12 false *D 5.427,0.375 5.656,0.563 0.229,0.188 10 true *a 0.156,0.875 0.396,1.073 0.24,0.198 10 false *b 1.01,2.302 1.25,2.5 0.24,0.198 10 true *b
*A w/ Vanity Light *B w/ Lane Departure Alert System
*C w/ Intrusion Sensor *D w/ Telematics Transceiver
*a Clamp *b Guide


i.

Disengage each guide.


ii.

w/ Telematics Transceiver:

1.

Disengage the clamp.



iii.

Peel off the pieces of each adhesive tape and remove the No. 1 roof wire.



b.

except TMMT Made:

B557961C01
3.177,3.052 2.813,2.76 true 4.656,1.375 4.344,1.073 true 4.99,1.729 4.656,1.604 true 1.448,0.781 1.208,0.906 true 1.146,1.271 0.875,1.469 true 4.198,0.177 4.563,0.396 0.365,0.219 12 false *A 2.563,2.583 2.896,2.792 0.333,0.208 12 false *A 1.5,0.594 1.813,0.75 0.313,0.156 10 false *a 0.708,1.438 1.021,1.594 0.313,0.156 10 false *b 4.188,0.896 4.5,1.052 0.313,0.156 10 false *b 5.052,1.667 5.365,1.823 0.313,0.156 10 false *a
*A w/ Vanity Light - -
*a Clamp *b Guide


i.

Disengage each guide.


ii.

Using a clip remover, disengage each clamp.


iii.

Peel off the pieces of each adhesive tape and remove the No. 1 roof wire.



c.
B461402C01
0,0 0,0 false
V113147

Remove in this Direction


w/ Vanity Light:

i.

Turn the visor connector approximately 90° counterclockwise and disconnect the visor connectors as shown in the illustration.

HINT:

Use the same procedures for the opposite side.




Hide 86101J 7.REMOVE NO. 2 ANTENNA CORD SUB-ASSEMBLY

Hide 63323E 8.REMOVE HEADLINING LIGHT CASE

a.

Remove the headlining light case.

B461394


Hide 63398 9.REMOVE ROOF HEADLINING SUPPORT PLATE (w/ Intrusion Sensor)

a.

Remove the roof headlining support plate.

B461395


Hide 63398 10.REMOVE ROOF HEADLINING SUPPORT PLATE (w/ Telematics Transceiver)

a.

Remove the roof headlining support plate.

B557962