Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › PANORAMIC VIEW MONITOR SYSTEM › from 2019.09
RM32H0E _56 Audio / Visual / Telematics _060571 PARK ASSIST / MONITORING _0404351 PANORAMIC VIEW MONITOR SYSTEM C

PARK ASSIST / MONITORING  PANORAMIC VIEW MONITOR SYSTEM  U0073  Control Module Communication Bus Off  U0100  Engine ECU Communication  U0126  Lost Communication with Steering Angle Sensor Module  U0129  Lost Communication with Brake System Control Module  U0140  Lost Communication with Body Control Module  U0163  Lost Communication with Navigation Control Module  U0233  Lost Communication with Blind Spot Monitor Master Module  U1110  Lost Communication with Clearance Warning ECU  


DESCRIPTION

These DTCs are stored if there is a malfunction in the CAN communication system connected to the parking assist ECU.

HINT:

If CAN communication system DTCs are stored, they may also be stored in other systems.


DTC No. Detection Item DTC Detection Condition Trouble Area
U0073 Control Module Communication Bus Off Control module communication bus off CAN communication system
U0100 Engine ECU Communication Lost communication with Engine ECU CAN communication system
U0126 Lost Communication with Steering Angle Sensor Module Lost communication with steering sensor CAN communication system
U0129 Lost Communication with Brake System Control Module Lost communication with skid control ECU (brake booster with master cylinder assembly) CAN communication system
U0140 Lost Communication with Body Control Module Lost communication with main body ECU (multiplex network body ECU) CAN communication system
U0163 Lost Communication with Navigation Control Module Lost communication with radio and display receiver assembly CAN communication system
U0233 Lost Communication with Blind Spot Monitor Master Module Lost communication with blind spot monitor sensor LH CAN communication system
U1110 Lost Communication with Clearance Warning ECU Lost communication with clearance warning ECU assembly CAN communication system

PROCEDURE

1.CHECK DTC OUTPUT
a.

Clear the DTCs.

Chassis > Circumference Monitoring Camera Control Module > Clear DTCs
50002 353

b.

Recheck for DTCs and check that no DTCs are output.

Chassis > Circumference Monitoring Camera Control Module > Trouble Codes
50001 353
HINT:
·

If CAN communication system DTCs are stored, they may also be stored in other systems.

·

If the CAN communication system has been inspected and repaired in other systems, the DTCs will not be output when rechecking for DTCs.

·

If these DTCs are output frequently, duplicate the conditions that cause the problem symptoms and perform troubleshooting again, even if the DTC was not output when rechecking for DTCs.

Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING




Result:
Result Proceed to
DTCs are output A
No DTCs are output B



A

B