Home › Vehicle Interior › METER / GAUGE / DISPLAY › METER / GAUGE SYSTEM › from 2019.09
RM32H0E _58 Vehicle Interior _060136 METER / GAUGE / DISPLAY _0294876 METER / GAUGE SYSTEM G

METER / GAUGE / DISPLAY  METER / GAUGE SYSTEM  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 83100 1.INSPECT COMBINATION METER ASSEMBLY

a.

Check speedometer operation

NOTICE:
·

The combination meter assembly receives the vehicle speed signal from the brake actuator assembly (skid control ECU) via CAN communication. Therefore, perform the following inspection referring to values on the Data List of the brake actuator assembly (skid control ECU) because it is the source of the vehicle speed signal.

·

Data List values of the brake actuator assembly (skid control ECU) are used for this inspection. Therefore, make sure to perform this inspection after confirming that DTCs are not output.

·

If the tire size or tire inflation pressure is not within the specified range, or the tires are excessively worn, the speedometer indication error will increase. Therefore, make sure to perform this inspection after checking that the tire size, tire inflation pressure and tire wear are in the specified range.



i.

Warm up the engine.


ii.

Connect the GTS to the DLC3.


iii.

Turn the ignition switch to ON.


iv.

Turn the GTS on.


v.

Enter the following menus: Chassis / ABS/VSC/TRC/EPB/EPB / Data List.


vi.

Read the Data List according to the display on the GTS.

Chassis > ABS/VSC/TRC/EPB > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
Vehicle Speed Maximum wheel speed sensor reading Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph) Vehicle stopped: 0 km/h (0 mph) When driving at constant speed: No large fluctuations
Chassis > ABS/VSC/TRC/EPB > Data List
Tester Display
Vehicle Speed
50003 105 42
Reference km/h (except Australia)
GTS Indication (km/h) Acceptable Range (km/h)
20 21.0 to 25.0
40 41.7 to 46.2
60 62.7 to 67.2
80 83.4 to 88.4
100 104.3 to 109.3
120 125.1 to 130.6
140 145.8 to 151.8
160 166.2 to 173.2
180 186.9 to 194.5
200 207.7 to 215.7
220 228.4 to 236.8

Reference km/h (for Australia)
GTS Indication (km/h) Acceptable Range (km/h)
20 20.6 to 24.2
40 41.2 to 44.8
60 61.8 to 65.4
80 82.4 to 86.0
100 103.0 to 106.6
120 123.6 to 127.4
140 144.2 to 148.2
160 164.9 to 168.9
180 185.7 to 189.3
200 206.3 to 209.9
220 226.7 to 230.7

Reference mph
GTS Indication (mph) Acceptable Range (mph)
20 21.0 to 23.5
40 42.0 to 44.5
60 62.5 to 66.0
80 83.1 to 87.1
100 103.9 to 108.4
120 124.7 to 129.6
140 145.4 to 150.7

OK:

Speedometer reading is within the acceptable range at each vehicle speed.


Chassis > ABS/VSC/TRC/EPB > Data List
Tester Display
Vehicle Speed


b.

Inspect tachometer

i.

Warm up the engine.


ii.

Connect the GTS to the DLC3.


iii.

Turn the ignition switch to ON.


iv.

Turn the GTS on.


v.

Enter the following menus: Powertrain / Engine / Data List. (for 8NR-FTS)


vi.

Enter the following menus: Powertrain / Engine and ECT / Data List. (for 3ZR-FAE)


vii.

Read the Data List according to the display on the GTS. (for 8NR-FTS)

Powertrain > Engine > Data List
Tester Display Measurement Item Range Normal Condition Reference Value Diagnostic Note
Engine Speed Engine speed Min.: 0 rpm, Max.: 16383 rpm
·

for 8NR-FTS with CVT: 680 to 780 rpm: Idling with warm engine

·

for 8NR-FTS with Manual Transaxle: 600 to 700 rpm: Idling with warm engine


- When the crankshaft position sensor is malfunctioning, "Engine Speed" is approximately 0 rpm or varies greatly from the actual engine speed.
Powertrain > Engine > Data List
Tester Display
Engine Speed
50003 234 9
Reference
GTS Indication (rpm) Acceptable Range (rpm)
Data in ( ) is for Reference
700 630 to 770
1000 (900 to 1100)
2000 (1850 to 2150)
3000 2800 to 3200
4000 (3800 to 4200)
5000 4800 to 5200
6000 (5750 to 6250)
7000 6700 to 7300
8000 (7700 to 8300)

OK:

Tachometer reading is within the acceptable range at each engine speed.



viii.

Read the Data List according to the display on the GTS. (for 3ZR-FAE)

Powertrain > Engine and ECT > Data List
Tester Display Measurement Item Range Normal Condition Reference Value Diagnostic Note
Engine Speed Engine speed Min.: 0 rpm, Max.: 16383 rpm 710 to 810 rpm: Idling with warm engine - When the crankshaft position sensor is malfunctioning, "Engine Speed" is approximately 0 rpm or varies greatly from the actual engine speed.
Powertrain > Engine > Data List
Tester Display
Engine Speed
50003 372 211
Reference
GTS Indication (rpm) Acceptable Range (rpm)
Data in ( ) is for Reference
700 630 to 770
1000 (900 to 1100)
2000 (1850 to 2150)
3000 2800 to 3200
4000 (3800 to 4200)
5000 4800 to 5200
6000 (5750 to 6250)
7000 6700 to 7300
8000 (7700 to 8300)

OK:

Tachometer reading is within the acceptable range at each engine speed.




c.

Check LED illumination (LED check)

i.

Check the illumination function of the warning or indicator lights listed below when turning the ignition switch to ON.

OK:
Warning or Indicator Light Control ECU Specified Condition
Brake warning light Brake actuator assembly (Skid control ECU) Warning or indicator light comes on for about 3 seconds after turning the ignition switch to ON.
VSC OFF indicator light Brake actuator assembly (Skid control ECU)
Slip indicator light Brake actuator assembly (Skid control ECU)
ABS warning light Brake actuator assembly (Skid control ECU)
Tire pressure warning light*1 Tire pressure warning and ECU receiver
PCS warning light*2 Millimeter wave radar sensor assembly
Automatic high beam indicator light*2 Main body ECU (Multiplex network body ECU)
EPB indicator light Brake actuator assembly (Skid control ECU)
EPB-Auto OFF indicator light*3 Brake actuator assembly (Skid control ECU)
EPB warning light Brake actuator assembly (Skid control ECU)
BSM OFF indicator light*5 Blind spot monitor sensor LH (B)
RCTA OFF indicator light*5 Blind spot monitor sensor LH (B)
SRS warning light Airbag sensor assembly Warning light comes on for about 6 seconds after turning the ignition switch to ON.
MIL (Check engine warning light) ECM Warning light comes on when the ignition switch to ON.
EPS warning light Power steering ECU assembly
IPA indicator light*4 Clearance warning ECU assembly


*1: w/ Tire Pressure Warning System

*2: w/ Toyota Safety Sense

*3: for Manual Transaxle

*4: w/ Parking Support Brake System

*5: w/ Blind Spot Monitor System