Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SYSTEM › from 2019.09
RM32H0E _56 Audio / Visual / Telematics _060571 PARK ASSIST / MONITORING _0297206 BLIND SPOT MONITOR SYSTEM C

PARK ASSIST / MONITORING  BLIND SPOT MONITOR SYSTEM  C1ABB  Blind Spot Monitor Master Module Beam Axis Inspection Incomplete  


DESCRIPTION

This DTC is stored when a beam axis adjustment has not been performed for the blind spot monitor sensor LH (Master).

HINT:

This DTC is always stored after replacing a blind spot monitor sensor. The purpose of this DTC is to ensure that a beam axis adjustment is performed. Completing the beam axis adjustment after replacing a blind spot monitor sensor prevents this DTC from being output.


DTC No. Detection Item DTC Detection Condition Trouble Area
C1ABB Blind Spot Monitor Master Module Beam Axis Inspection Incomplete A beam axis adjustment has not been performed Blind spot monitor sensor LH (Master)

PROCEDURE

1.PERFORM BLIND SPOT MONITOR BEAM AXIS ADJUSTMENT
a.

Change the blind spot monitor sensor LH (Master) to Test Mode using the GTS.

HINT:

Refer to Blind Spot Monitor Beam Axis Confirmation.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>BLIND SPOT MONITOR SYSTEM>OPERATION CHECK



Result:
Proceed to
NEXT



NEXT

END