Home › Power Source / Network › NETWORKING › NETWORK GATEWAY ECU (for LHD) › from 2019.09
RM32H0E _57 Power Source / Network _059621 NETWORKING _0292522 NETWORK GATEWAY ECU(for LHD) A

NETWORKING  NETWORK GATEWAY ECU(for LHD)  REMOVAL  


PROCEDURE

Hide 55433B 1.REMOVE NO. 2 INSTRUMENT PANEL LOWER FINISH PANEL

Hide 82877 2.REMOVE ECU INTEGRATION BOX RH

a.
E357030C01
0.854,0.135 1.094,0.344 0.24,0.208 10 true *a 0.844,0.427 1.083,0.635 0.24,0.208 10 true *a 0.844,0.74 1.083,0.948 0.24,0.208 10 true *a
*a w/ Smart Key System


Disconnect the connector.


b.

w/ Smart Key System:

i.

Disconnect the 3 connectors.



c.

Using a clip remover, disengage the wire harness clamp.


d.
E357031

Remove the bolt, 2 nuts and ECU integration box RH.


Hide 89111 3.REMOVE CENTRAL GATEWAY ECU (NETWORK GATEWAY ECU)

a.

Disengage the claws to remove the central gateway ECU (network gateway ECU).

E357194

NOTICE:
·

If the ECU integration box RH is deformed or damaged, replace it.

·

Do not bend the claws more than necessary.