Home › Vehicle Interior › SEAT › POWER SEAT SWITCH › 2019.09–2020.08
RM32H0E _58 Vehicle Interior _059623 SEAT _0404464 POWER SEAT SWITCH A

SEAT  POWER SEAT SWITCH  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the front power seat switch removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link

*1: When performing learning using the GTS.

Click here(Click here)

Disconnect cable from negative battery terminal Perform steering sensor zero point calibration Lane departure alert system (w/ Steering Control) (Click here)
Toyota parking assist-sensor system*1
Parking support brake system*1
Simple intelligent parking assist system*1
Pre-collision system
Memorize steering angle neutral point Panoramic view monitor system (Click here)
Initialize back door lock Power door lock control system (Click here)

CAUTION:
·
B458500

Be sure to read Precaution thoroughly before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION

·
B407261

Wear protective gloves. Sharp areas on the parts may injure your hands.



HINT:
·

Power seat is available only on the driver side.

·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 71074S 2.DISCONNECT SEPARATE TYPE FRONT SEATBACK COVER

Hide 71868A 3.REMOVE NO. 1 FRONT SEAT INNER CUSHION SHIELD

Hide 71812D 4.REMOVE FRONT SEAT CUSHION SHIELD

Hide 84921D 5.REMOVE SLIDE AND VERTICAL POWER SEAT SWITCH KNOB

Hide 84921K 6.REMOVE RECLINING POWER SEAT SWITCH KNOB

Hide 72714 7.REMOVE SEAT ADJUSTER SHIELD CLAMP BRACKET

Hide 84922C 8.REMOVE FRONT POWER SEAT SWITCH

a.
B439702

Remove the 2 screws and front power seat switch from the front seat cushion shield.