The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the front lumbar power seat switch removal/installation are shown below.
Be sure to read Precaution thoroughly before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
Wear protective gloves. Sharp areas on the parts may injure your hands.
Front lumbar power seat switch is available only on the driver side.
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
1.REMOVE FRONT SEAT ASSEMBLY
71074S
2.DISCONNECT SEPARATE TYPE FRONT SEATBACK COVER
72495
3.REMOVE VERTICAL ADJUSTING HANDLE
72538
4.REMOVE RECLINING HINGE OUTER COVER
72526A
5.REMOVE RECLINING ADJUSTER RELEASE HANDLE
71849F
6.REMOVE SEAT ADJUSTER COVER CAP
71812D
7.REMOVE FRONT SEAT CUSHION SHIELD
84922A
8.REMOVE FRONT LUMBAR POWER SEAT SWITCH
Remove the 2 screws.
Disengage the guides to remove the front lumbar power seat switch.