Home › Vehicle Interior › SEAT › LUMBAR SUPPORT ADJUSTER ASSEMBLY › 2019.09–2020.08
RM32H0E _58 Vehicle Interior _059623 SEAT _0292529 LUMBAR SUPPORT ADJUSTER ASSEMBLY A

SEAT  LUMBAR SUPPORT ADJUSTER ASSEMBLY  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the lumbar support adjuster assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link

*1: When performing learning using the GTS.

Click here(Click here)

Disconnect cable from negative battery terminal Perform steering sensor zero point calibration Lane departure alert system (w/ Steering Control) (Click here)
Toyota parking assist-sensor system*1
Parking support brake system*1
Simple intelligent parking assist system*1
Pre-collision system
Memorize steering angle neutral point Panoramic view monitor system (Click here)
Initialize back door lock Power door lock control system (Click here)

CAUTION:
·
B458500

Be sure to read Precaution thoroughly before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION

·
B407261

Wear protective gloves. Sharp areas on the parts may injure your hands.



HINT:
·

Front lumbar power seat switch is available only on the driver side.

·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 1.REMOVE SEPARATE TYPE FRONT SEATBACK COVER WITH PAD (for Manual Seat)

Hide 2.REMOVE SEPARATE TYPE FRONT SEATBACK COVER WITH PAD (for Power Seat)

Hide 72760D 3.REMOVE LUMBAR SUPPORT ADJUSTER ASSEMBLY

a.

for Manual Seat:

i.
B453970

Disconnect the connector.


ii.

Disengage the clamp.



b.

for Power Seat:

i.
B558459

Disconnect the 2 connectors.


ii.

Disengage the clamp.



c.
B453971

Disengage the claws to separate the 2 front seatback edge protectors from the front seatback frame sub-assembly.


d.
B453972C01
0,0 0,0 false
V113147

Remove in this Direction


Disengage the guides to remove the lumbar support adjuster assembly from the front seatback frame sub-assembly as shown in the illustration.


e.
B458495

Remove the 2 front seatback edge protectors from the lumbar support adjuster assembly.


Hide 79977A 4.REMOVE SEATBACK FELT

B558485

a.

Remove the seatback felt from the lumbar support adjuster assembly.