Home › Vehicle Interior › SEAT BELT › FRONT SEAT INNER BELT ASSEMBLY › 2019.09–2020.08
RM32H0E _58 Vehicle Interior _060065 SEAT BELT _0294234 FRONT SEAT INNER BELT ASSEMBLY A

SEAT BELT  FRONT SEAT INNER BELT ASSEMBLY  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during the front seat inner belt assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link

*1: When performing learning using the GTS.

Click here(Click here)

Disconnect cable from negative battery terminal Perform steering sensor zero point calibration Lane departure alert system (w/ Steering Control) (Click here)
Toyota parking assist-sensor system*1
Parking support brake system*1
Simple intelligent parking assist system*1
Pre-collision system
Memorize steering angle neutral point Panoramic view monitor system (Click here)
Initialize back door lock Power door lock control system (Click here)

CAUTION:
·
B458500

Be sure to read Precaution thoroughly before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION

·
B407261

Wear protective gloves. Sharp areas on the parts may injure your hands.



HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.

·

Use the same procedure for the driver side and front passenger side.

·

The procedure listed below is for the driver side.



PROCEDURE

Hide 1.REMOVE FRONT SEAT ASSEMBLY (for Manual Seat)

Hide 2.REMOVE FRONT SEAT ASSEMBLY (for Power Seat)

Hide 73240 3.REMOVE FRONT SEAT INNER BELT ASSEMBLY (for Driver Side)

a.

for Manual Seat:

i.
B458462

Disengage the clamp and claw.


ii.
B458411

Disengage the clamps.


iii.

Remove the nut and front seat inner belt assembly.



b.

for Power Seat:

i.
B557309

Disengage the clamps and claw.


ii.
B557311

Disengage the clamps.


iii.

Remove the nut and front seat inner belt assembly.


iv.

Remove the front seat belt anchor plate.



Hide 73230 4.REMOVE FRONT SEAT INNER BELT ASSEMBLY (for Front Passenger Side)

a.
B458463

Disconnect the connector.


b.

Disengage the clamps and claw.


c.
B458413

Disengage the clamp.


d.

Remove the nut and front seat inner belt assembly.


e.

Remove the front seat belt anchor plate.