Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM (for Radio and Display Type) › from 2019.09
RM32H0E _56 Audio / Visual / Telematics _060227 AUDIO / VIDEO _0295690 AUDIO AND VISUAL SYSTEM(for Radio and Display Type) J

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM(for Radio and Display Type)  Voice Guidance Circuit between Radio Receiver and Stereo Component Amplifier  


DESCRIPTION

This circuit is used when the voice switch of the steering pad switch assembly is pushed.

Using this circuit, the radio and display receiver assembly sends signals to the stereo component amplifier assembly.

WIRING DIAGRAM

E425793E02
0.344,2.802 1.542,3.313 1.198,0.51 10 false Radio and Display Receiver Assembly 0.354,2.646 0.906,2.99 0.552,0.344 10 false F132 0.979,0.646 1.323,0.885 0.344,0.24 10 false RL+ 1,1.417 1.344,1.656 0.344,0.24 10 false RL- 5.927,0.646 6.271,0.885 0.344,0.24 10 false II1+ 5.677,2.635 6.26,2.896 0.583,0.26 10 false F152 1.365,0.542 1.573,0.76 0.208,0.219 10 false 3 1.365,1.302 1.573,1.521 0.208,0.219 10 false 8 5.646,0.531 5.896,0.74 0.25,0.208 10 false 15 5.646,1.313 5.896,1.51 0.25,0.198 10 false 14 5.635,2.115 5.896,2.333 0.26,0.219 10 false 18 5.927,1.438 6.271,1.677 0.344,0.24 10 false II1- 5.927,2.219 6.417,2.427 0.49,0.208 10 false SLD1 3.26,1.75 4.01,1.969 0.75,0.219 10 false (Shielded) 5.667,2.792 6.875,3.208 1.208,0.417 10 false Stereo Component Amplifier Assembly

PROCEDURE

1.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - STEREO COMPONENT AMPLIFIER ASSEMBLY)
a.

Disconnect the F132 radio and display receiver assembly connector.


b.

Disconnect the F152 stereo component amplifier assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
F132-3 (RL+) - F152-15 (II1+) Always Below 1 Ω
F132-8 (RL-) - F152-14 (II1-) Always Below 1 Ω
F152-18 (SLD1) - Body ground Always 10 kΩ or higher
F132-3 (RL+) or F152-15 (II1+) - Body ground Always 10 kΩ or higher
F132-8 (RL-) or F152-14 (II1-) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR