The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during steering gear assembly removal/installation are shown below.
1. ALIGN FRONT WHEELS FACING STRAIGHT AHEAD
45100
2.SECURE STEERING WHEEL ASSEMBLY
Secure the steering wheel with the seat belt in order to prevent rotation.
This operation is useful to prevent damage to the spiral cable.
45259A
3.REMOVE COLUMN HOLE COVER SILENCER SHEET
45260
4.SEPARATE NO. 2 STEERING INTERMEDIATE SHAFT ASSEMBLY
45025D
5.SEPARATE NO. 1 STEERING COLUMN HOLE COVER SUB-ASSEMBLY
Separate the clip (A), disengage the clip (B) from the vehicle body and separate the No. 1 steering column hole cover sub-assembly.
Do not damage the clips (A) or (B).
6.REMOVE FRONT WHEELS
43215
7.REMOVE STEERING KNUCKLE SEAL (w/ Seal)
Use the same procedure for both sides.
|
Remove in this Direction |
Disengage the claw to remove the steering knuckle seal as shown in the illustration.
45047
8.SEPARATE TIE ROD END SUB-ASSEMBLY LH
Remove the cotter pin and nut.
Install SST to the tie rod end sub-assembly LH.
Make sure that the upper ends of the tie rod end sub-assembly LH and SST are aligned.
Secure SST using a string.
Be sure to tighten the string firmly to secure SST to the steering knuckle LH to prevent SST from falling off.
Using SST, separate the tie rod end sub-assembly LH from the steering knuckle LH.
| *a | String | *b | Molybdenum Grease Application Area |
| *c | Place wrench here | *d | Center Nut |
|
Turn | - | - |
Apply molybdenum grease to the bolt threads and the tip of SST.
Be sure to tighten the string firmly to secure SST to the steering knuckle LH to prevent SST from falling off.
Install SST with the center nut so that (A) and (B) shown in the illustration are parallel. Otherwise, the ball joint dust cover may be damaged.
Be sure to place the wrench on the part shown in the illustration.
Do not damage the front disc brake dust cover.
Do not damage the ball joint dust cover.
Do not damage the steering knuckle LH.
45046
9.SEPARATE TIE ROD END SUB-ASSEMBLY RH
Perform the same procedure as for the LH side.
10.REMOVE STEERING LINK ASSEMBLY
for AWD:
Disengage the clamp and disconnect the connector.
Remove the bolt and separate the wiring harness clamp bracket from the front suspension crossmember sub-assembly.
for 2WD:
Disconnect the connector.
Remove the bolt and separate the wiring harness clamp bracket from the front suspension crossmember sub-assembly.
Remove the 2 bolts, 2 nuts and steering link assembly from the front suspension crossmember sub-assembly.
Because the nut has its own stopper, do not turn the nut. Loosen the bolt with the nut secured.
Remove the No. 1 steering column hole cover sub-assembly from the steering link assembly.
|
Remove in this Direction |
Remove the steering link assembly as shown in the illustration.
11.SECURE STEERING LINK ASSEMBLY
| *a | Protective Tape |
Using SST, secure the steering link assembly in a vise.
Wrap SST with protective tape before use.
45047
12.REMOVE TIE ROD END SUB-ASSEMBLY LH
| *a | Matchmark |
Put matchmarks on the tie rod end sub-assembly LH and steering gear assembly.
Remove the tie rod end sub-assembly LH and lock nut.
45046
13.REMOVE TIE ROD END SUB-ASSEMBLY RH
Perform the same procedure as for the LH side.