The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the seat position airbag sensor removal/installation are shown below.
After the ignition switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) battery terminal.
Use the same procedure for RHD and LHD vehicles.
The following procedure is for LHD vehicles.
1.REMOVE FRONT SEAT ASSEMBLY (for Manual Seat)
7181B
2.REMOVE FRONT SEAT CUSHION WIRE HARNESS HOLDER (for Power Seat)
72277A
3.REMOVE SEAT SLIDE POSITION SENSOR PROTECTOR
for Manual Seat:
Disengage the clamp.
Disconnect the connector.
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |
Pull the seat slide position sensor protector in the direction indicated by the arrow (1), to disengage the pin, and then slide the seat slide position sensor protector in the direction indicated by the arrows (2) shown in the illustration to remove it.
89178A
4.REMOVE SEAT POSITION AIRBAG SENSOR (for Manual Seat)
Using a T30 "TORX" socket wrench, remove the "TORX" bolt and seat position airbag sensor.
89178A
5.REMOVE SEAT POSITION AIRBAG SENSOR (for Power Seat)
Using a T30 "TORX" socket wrench, remove the "TORX" bolt and seat position airbag sensor with bracket.
Using a T30 "TORX" socket wrench, remove the "TORX" bolt and seat position airbag sensor from the bracket.