Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › PARKING ASSIST ECU › 2019.09–2020.08
RM32H0E _56 Audio / Visual / Telematics _060571 PARK ASSIST / MONITORING _0404740 PARKING ASSIST ECU A

PARK ASSIST / MONITORING  PARKING ASSIST ECU  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during parking assist ECU removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link

*1: When performing learning using the GTS.

Click here(Click here)

Disconnect cable from negative battery terminal Perform steering sensor zero point calibration Lane departure alert system (w/ Steering Control) (Click here)
Simple intelligent parking assist system*1
Toyota parking assist-sensor system*1
Parking support brake system*1
Pre-collision System
Memorize steering angle neutral point Panoramic view monitor system (Click here)
Initialize back door lock Power door lock control system (Click here)
Replacement of the parking assist ECU
·

Parking assist ECU initialization

·

Memorize steering angle neutral point


Panoramic View Monitor System (Click here)

CAUTION:
B458500

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION


NOTICE:

After the ignition switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) battery terminal.


HINT:
·

Use the same procedure for LHD and RHD vehicles.

·

The procedure listed below is for the LHD vehicles.



PROCEDURE

Hide 1.REMOVE FRONT SEAT ASSEMBLY RH

HINT:

Use the same procedure as for the LH side.

Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Manual Seat)>REMOVAL


Hide 86796 2.REMOVE PARKING ASSIST ECU COVER

a.
E426513C01
0,0 0,0 false
V113147

Remove in this Direction (1)
V113148

Remove in this Direction (2)


Disengage the clips and guide to remove the parking assist ECU cover as shown in the illustration.


Hide 86792C 3.REMOVE PARKING ASSIST ECU

a.
E426535

Disconnect the connector.


b.

Turn back the part of the front floor carpet assembly.


c.
E426534

Remove the 2 bolts and parking assist ECU.