Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › PANORAMIC VIEW MONITOR SWITCH › from 2019.09
RM32H0E _56 Audio / Visual / Telematics _060571 PARK ASSIST / MONITORING _0404741 PANORAMIC VIEW MONITOR SWITCH G

PARK ASSIST / MONITORING  PANORAMIC VIEW MONITOR SWITCH  INSPECTION  


PROCEDURE

Hide 84721B 1.INSPECT PANORAMIC VIEW MONITOR SWITCH

a.

Check the resistance.

i.
E107908C38
2.333,1.75 2.167,1.75 2.167,1.75 2.167,1.333 true 1.167,1.75 1.333,1.75 1.333,1.75 1.333,1.333 true 0.125,0.073 0.406,0.25 0.281,0.177 10 false *a 2.385,1.667 2.75,1.865 0.365,0.198 10 false E 1.042,1.667 1.385,1.875 0.344,0.208 10 false D
*a Component without harness connected
(Panoramic View Monitor Switch)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
1 (E) - 4 (D) Push (ON) Below 1 Ω
1 (E) - 4 (D) Not push (OFF) 10 kΩ or higher


If the result is not as specified, replace the panoramic view monitor switch.



b.
E107908C30
1.927,1.333 2.167,1.833 true 1.583,1.333 1.302,1.854 true 2.135,1.917 2.448,2.115 0.313,0.198 10 false ILL- 1.167,1.917 1.583,2.094 0.417,0.177 10 false ILL+ 0.083,0.063 0.396,0.26 0.313,0.198 10 false *a
*a Component without harness connected
(Panoramic View Monitor Switch)


Check that the switch illuminates.

i.

Apply battery voltage to the panoramic view monitor switch and check that the switch illuminates.

OK:
Measurement Condition Specified Condition
Battery positive (+) → Terminal 3 (ILL+)
Battery negative (-) → Terminal 2 (ILL-)
Illuminates


If the result is not as specified, replace the panoramic view monitor switch.