Home › Drivetrain › GF1A (TRANSFER / 4WD / AWD) › DYNAMIC TORQUE CONTROL AWD SYSTEM › from 2019.09
RM32H0E _52 Drivetrain _059725 GF1A TRANSFER / 4WD / AWD _0298220 DYNAMIC TORQUE CONTROL AWD SYSTEM D

GF1A TRANSFER / 4WD / AWD  DYNAMIC TORQUE CONTROL AWD SYSTEM  CALIBRATION  


DESCRIPTION


a.

When the 4WD ECU assembly is replaced with a normal one from another vehicle or the acceleration sensor (airbag sensor assembly) is replaced, perform calibration.


b.

Follow the chart to perform calibration.

Part Replaced Necessary Operation
4WD ECU assembly (When replaced with a normal one from another vehicle) Clear zero point calibration data
Acceleration sensor (airbag sensor assembly)
1.

Clear zero point calibration data

2.

Perform vehicle stability control system calibration

Click here(Click here)



HINT:

When the 4WD ECU assembly is replaced with a new one, calibration is unnecessary.




PERFORM CALIBRATION


a.

Clear the zero point calibration data.

i.

Turn the ignition switch off.


ii.

Connect the GTS to the DLC3.


iii.

Turn the ignition switch to ON.


iv.

Turn the GTS on.


v.

Enter the following menus: Chassis / Four Wheel Drive / Utility / Reset Memory.

Chassis > Four Wheel Drive > Utility
Tester Display
Reset Memory
50005 118 2119

vi.

Operate the GTS to clear the data.