Home › Suspension › FRONT SUSPENSION › FRONT STABILIZER BAR › from 2019.09
RM32H0E _53 Suspension _059519 FRONT SUSPENSION _0291586 FRONT STABILIZER BAR A

FRONT SUSPENSION  FRONT STABILIZER BAR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during front stabilizer bar removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Front wheel alignment adjustment
1.

Clear zero point calibration data.

2.

Perform yaw rate and acceleration sensor zero point calibration.


·

DTCs are stored

·

ABS warning light illuminates

·

Slip indicator light illuminates

·

VSC disabled or malfunctions


(Click here)
Suspension, tires, etc.
(The vehicle height changes because of suspension or tire replacement)
Initialize No. 1 headlight ECU sub-assembly LH Automatic headlight beam level control system (Click here)
·

Measurement of ultrasonic sensor detection angle

·

Ultrasonic sensor detection angle registration


·

Parking support brake system

·

Simple intelligent parking assist system


(Click here)
·

Parking assist ECU initialization

·

Adjust steering angle


Panoramic view monitor system (Click here)

PROCEDURE

Hide 51201 1.REMOVE FRONT SUSPENSION CROSSMEMBER SUB-ASSEMBLY

Hide 2.REMOVE STEERING LINK ASSEMBLY

a.
C366715

Remove the 2 bolts, 2 nuts and steering link assembly from the front suspension crossmember sub-assembly.

NOTICE:

Because the nut has its own stopper, do not turn the nut. Loosen the bolt with the nut secured.



Hide 48810 3.REMOVE FRONT STABILIZER LINK ASSEMBLY LH

a.
C365735

Remove the nut and front stabilizer link assembly LH from the front stabilizer bar LH.


Hide 48820B 4.REMOVE FRONT STABILIZER LINK ASSEMBLY RH

HINT:

Perform the same procedure as for the LH side.


Hide 48829A 5.REMOVE FRONT NO. 1 STABILIZER BRACKET LH

a.
C365737

Remove the 2 bolts and front stabilizer bracket LH from the front suspension crossmember sub-assembly.


Hide 48824A 6.REMOVE FRONT NO. 1 STABILIZER BRACKET RH

HINT:

Perform the same procedure as for the LH side.


Hide 48811 7.REMOVE FRONT STABILIZER BAR

a.

Remove the front stabilizer bar with 2 front stabilizer bar bushings from the front suspension crossmember sub-assembly.


Hide 48815E 8.REMOVE FRONT STABILIZER BAR BUSHING LH

a.

Remove the front stabilizer bar bushing LH from the front stabilizer bar.


Hide 48815D 9.REMOVE FRONT STABILIZER BAR BUSHING RH

HINT:

Perform the same procedure as for the LH side.