Home › Suspension › REAR SUSPENSION › REAR STABILIZER BAR (for AWD) › from 2019.09
RM32H0E _53 Suspension _059601 REAR SUSPENSION _0292272 REAR STABILIZER BAR(for AWD) A

REAR SUSPENSION  REAR STABILIZER BAR(for AWD)  REMOVAL  


PROCEDURE

Hide 1.REMOVE REAR WHEEL

Hide 48840A 2.REMOVE REAR STABILIZER LINK ASSEMBLY LH

a.
C404916

Remove the cap.


b.
C365350N01
1.656,1.469 1.813,1.667 0.156,0.198 10 true A 0.979,4.094 1.135,4.292 0.156,0.198 10 true B

Loosen the nut (A) of the rear stabilizer link assembly LH.

HINT:

If the ball joint turns together with the nut, use a 6 mm hexagon socket wrench to hold the stud bolt.



c.

Loosen the nut (B) of the rear stabilizer link assembly LH.

NOTICE:

When loosing the nut, keep the bolt from rotating.



d.
C365351C01
1.938,1.458 2.24,1.458 false 2.094,1.802 2.396,1.802 false 2.281,1.344 2.594,1.542 0.313,0.198 10 false *a 2.427,1.688 2.74,1.885 0.313,0.198 10 false *b
*a Wooden Block
*b Jack


Using a jack and a wooden block, support the rear No. 2 suspension arm assembly.

NOTICE:
·

When jacking up the rear No. 2 suspension arm assembly, be sure to jack it up slowly.

·

Make sure to perform this operation with the vehicle kept as low as possible.




e.
C365350

Remove the bolt, 2 nuts and rear stabilizer link assembly LH.


Hide 48830D 3.REMOVE REAR STABILIZER LINK ASSEMBLY RH

HINT:

Perform the same procedure as for the LH side.


Hide 48812 4.REMOVE REAR STABILIZER BAR

a.
C365352

Remove the 4 bolts, rear stabilizer bar, 2 rear No. 1 stabilizer bar brackets and 2 rear stabilizer bushings from the rear suspension member sub-assembly.


Hide 48832A 5.REMOVE REAR NO. 1 STABILIZER BAR BRACKET

a.
C365353

Remove the 2 rear No. 1 stabilizer bar brackets from the 2 rear stabilizer bushings.


Hide 48818 6.REMOVE REAR STABILIZER BUSHING

a.
C365354

Remove the 2 rear stabilizer bushings from the rear stabilizer bar.