Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › RADIATOR GRILLE › 2019.09–2020.08
RM32H0E _59 Vehicle Exterior _060783 EXTERIOR PANELS / TRIM _0298080 RADIATOR GRILLE A

EXTERIOR PANELS / TRIM  RADIATOR GRILLE  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during the radiator grille removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Millimeter wave radar sensor assembly Adjust millimeter wave radar sensor assembly
·

Dynamic radar cruise control system

·

Forward recognition camera system

·

Lane departure alert system (w/ Steering Control)

·

Pre-collision system


(Click here)
Front bumper assembly
·

Measurement of ultrasonic sensor detection angle

·

Ultrasonic sensor detection angle registration


·

Parking support brake system

·

Simple intelligent parking assist system


(Click here)
·

Front bumper assembly

·

Radiator grille


Front television camera view adjustment Panoramic view monitor system (Click here)

PROCEDURE

Hide 88211B 1.REMOVE MILLIMETER WAVE RADAR SENSOR ASSEMBLY (w/ Toyota Safety Sense)

Hide 2.REMOVE FRONT BUMPER ASSEMBLY (w/o Toyota Safety Sense)

Hide 53111 3.REMOVE RADIATOR GRILLE

a.

w/o Panoramic View Monitor System:

i.
B557809

Disengage the wire harness clamp.



b.

w/ Panoramic View Monitor System:

i.
B557983

Disengage the wire harness clamps.



c.
B557803

Remove the 2 bolts.


d.

Disengage the claws to remove the radiator grille.