Home › Brake › BRAKE SYSTEM (OTHER) › VACUUM PUMP (for 8NR-FTS) › 2019.09–2020.08
RM32H0E _54 Brake _060040 BRAKE SYSTEM (OTHER) _0299736 VACUUM PUMP(for 8NR-FTS) A

BRAKE SYSTEM (OTHER)  VACUUM PUMP(for 8NR-FTS)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the vacuum pump assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects / Inoperative when not performed Link

*1: When performing learning using the GTS

Click here(Click here)

Disconnect cable from negative battery terminal Perform steering sensor zero point calibration Lane departure alert system (w/ Steering Control) (Click here)
Toyota parking assist-sensor system*1
Parking support brake system*1
Simple intelligent parking assist system*1
Pre-collision system
Memorize steering angle neutral point Panoramic view monitor system (Click here)
Initialize back door lock Power door lock control system (Click here)

PROCEDURE

Hide 28800 1.REMOVE BATTERY

Hide 2.DISCONNECT UNION TO CONNECTOR TUBE HOSE

a.
C366917

Slide the clip and disconnect the union to connector tube hose from the vacuum pump assembly.


Hide 29300 3.REMOVE VACUUM PUMP ASSEMBLY

a.
C366918

Disconnect the No. 1 vacuum transmitting hose assembly from the vacuum pump assembly.


b.
C366919

Remove the 3 bolts and vacuum pump assembly from the engine assembly.


c.
C326537C02
1.698,1.167 2.094,0.406 2.094,0.406 2.427,0.406 true 0.823,2.021 1.125,2.021 1.125,2.021 1.125,1.781 true 2.469,0.344 2.781,0.5 0.313,0.156 10 false *1 0.656,1.958 0.969,2.115 0.313,0.156 10 false *2
*1 No. 2 O-ring
*2 No. 3 O-ring


Remove the No. 2 O-ring and No. 3 O-ring from the vacuum pump assembly.