Home › Brake › BRAKE (FRONT) › FRONT BRAKE (for TMC Made) › from 2019.09
RM32H0E _54 Brake _060041 BRAKE (FRONT) _0407337 FRONT BRAKE(for TMC Made) G

BRAKE (FRONT)  FRONT BRAKE(for TMC Made)  INSPECTION  


PROCEDURE

Hide 1.INSPECT BRAKE CYLINDER AND PISTON

a.

Check the front disc brake cylinder bore and front disc brake piston for rust and scoring. If necessary, replace the front disc brake cylinder assembly and front disc brake piston.


Hide 2.INSPECT PAD LINING THICKNESS

a.
C369842C04
2.219,0.969 2.385,0.719 false 2.406,0.573 2.719,0.729 0.313,0.156 10 false *a
*a Ruler


Using a ruler, measure the front disc brake pad lining thickness.

Standard Thickness:

11.0 mm (0.433 in.)


Minimum Thickness:

1.0 mm (0.0394 in.)


HINT:
·

If a front disc brake pad lining thickness is less than the minimum thickness, replace the front disc brake pads.

·

Be sure to check front disc thickness when replacing the front disc brake pads with new ones.




Hide 3.INSPECT FRONT DISC BRAKE PAD SUPPORT PLATE

a.

Make sure that the front disc brake pad support plates have sufficient rebound, no deformation, cracks or wear, and that all rust and dirt is cleaned off. If necessary, replace the front disc brake pad support plates.


b.

Before installing the front disc brake pad support plates on the front disc brake cylinder mounting, clean the installation surface of the brake cylinder mounting with brake cleaner.


c.

Install the front disc brake pad support plates, and check that there is no looseness or deformation.


d.

Before installing the front disc brake pads, check that the brake pad support plates have spring force.


e.

Install the brake pads, and check that they do not come off easily.


Hide 4.INSPECT DISC THICKNESS

a.
C365985C01
1.583,1.385 1.333,1.833 true 1.177,1.75 1.49,1.906 0.313,0.156 10 false *a
*a Micrometer


Using a micrometer, measure the front disc thickness.

Standard Thickness:

28.0 mm (1.10 in.)


Minimum Thickness:

25 mm (0.984 in.)


HINT:

If the front disc thickness is less than the minimum thickness, replace the front disc.



Hide 5.INSPECT DISC RUNOUT

a.

Inspect the front axle hub bearing looseness and front axle hub runout.

Click hereDrivetrain>AXLE AND DIFFERENTIAL>FRONT AXLE HUB>ON-VEHICLE INSPECTION


b.

Align the matchmarks of the front disc and front axle hub, and temporarily install the front disc with the 5 hub nuts.

Torque:
103 N*m (1050 kgf*cm, 76 ft.*lbf)


c.
C365986C01
1.927,1.229 2.292,1.646 true 2.344,1.573 2.656,1.729 0.313,0.156 10 false *a
*a Dial Indicator


Using a dial indicator, measure the disc runout 10 mm (0.394 in.) from the outer edge of the front disc.

Maximum Disc Runout:

0.05 mm (0.00196 in.)


NOTICE:

Keep the magnet of the dial indicator away from the front speed sensor.


HINT:

If the runout exceeds the maximum value, change the installation position of the front disc to minimize the runout. If the runout exceeds the maximum even when the installation position is changed, grind the front disc. If the front disc thickness is less than the minimum, replace the front disc.



d.

Remove the 5 hub nuts and front disc.