Home › Brake › BRAKE (FRONT) › FRONT BRAKE (for TMMT Made) › from 2019.09
RM32H0E _54 Brake _060041 BRAKE (FRONT) _0407338 FRONT BRAKE(for TMMT Made) A

BRAKE (FRONT)  FRONT BRAKE(for TMMT Made)  REMOVAL  


CAUTION / NOTICE / HINT

NOTICE:
·

Immediately after installing the brake pads, the braking performance may be reduced. Always perform a road test in a safe place while paying attention to the surroundings.

·

After replacing the front disc brake pads, always perform a road test to check the braking performance and check for vibrations.



HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 1.REMOVE FRONT WHEEL

Hide 2.DRAIN BRAKE FLUID

NOTICE:

If brake fluid leaks onto any painted surface, immediately wash it off.


Hide 47313J 3.DISCONNECT FRONT FLEXIBLE HOSE

a.
C365971

Remove the union bolt and gasket, and disconnect the front flexible hose from the front disc brake cylinder assembly.


Hide 47750 4.REMOVE FRONT DISC BRAKE CYLINDER ASSEMBLY

a.
C365972C01
1.323,1.521 1.635,1.677 0.313,0.156 10 false *a 1.917,1.594 2.229,1.75 0.313,0.156 10 false *b
*a Turn
*b Hold


Hold the 2 front disc brake cylinder slide pins and remove the 2 bolts and front disc brake cylinder assembly.


Hide 5.REMOVE FRONT DISC BRAKE PAD

a.
C365973

Remove the 2 front disc brake pads from the front disc brake cylinder mounting.


Hide 04945 6.REMOVE FRONT DISC BRAKE ANTI-SQUEAL SHIM KIT

Hide 7.REMOVE FRONT DISC BRAKE PAD SUPPORT PLATE

a.
C365975

Remove the 4 front disc brake pad support plates from the front disc brake cylinder mounting.

NOTICE:

Each front disc brake pad support plate has a different shape. Be sure to put an identification mark on each front disc brake pad support plate so that it can be reinstalled to its original position.



Hide 8.REMOVE FRONT DISC BRAKE CYLINDER SLIDE PIN

a.
C365976

Remove the 2 front disc brake cylinder slide pins from the front disc brake cylinder mounting.


b.
C365977C01
1.948,1.385 2.438,1.427 false 1.75,1.271 2.063,1.469 0.313,0.198 10 false *a
*a Protective Tape


Using a screwdriver with its tip wrapped with protective tape, remove the front disc brake cylinder slide bushing from the front disc brake cylinder slide pin (lower side).

NOTICE:

Do not damage the front disc brake cylinder slide pin.



Hide 9.REMOVE FRONT DISC BRAKE BUSHING DUST BOOT

a.
C366018

Remove the 2 front disc brake bushing dust boots from the front disc brake cylinder mounting.


Hide 47722 10.REMOVE FRONT DISC BRAKE CYLINDER MOUNTING

a.
C365978

Remove the 2 bolts and front disc brake cylinder mounting from the steering knuckle.


Hide 43512 11.REMOVE FRONT DISC

a.
C365979C01
1.875,1.021 2.635,0.854 2.635,0.854 1.865,0.948 true 2.708,0.76 3.021,0.917 0.313,0.156 10 false *a
*a Matchmark


Put matchmarks on the front disc and the front axle hub sub-assembly.

HINT:

If the front disc needs to be replaced, matchmarks do not have to be put.



b.

Remove the front disc.