47547B
1.TEMPORARILY TIGHTEN FRONT DISC BRAKE BLEEDER PLUG
Temporarily install the front disc brake bleeder plug to the front disc brake cylinder assembly.
Fully tighten the front disc brake bleeder plug after bleeding the system.
31478B
2.INSTALL FRONT DISC BRAKE BLEEDER PLUG CAP
Install the front disc brake bleeder plug cap to the front disc brake bleeder plug.
3.INSTALL PISTON SEAL
|
Lithium Soap Base Glycol Grease |
Apply lithium soap base glycol grease to the entire circumference of a new piston seal.
| *1 | Piston Seal |
| *2 | Front Disc Brake Cylinder Assembly |
Install the piston seal to the front disc brake cylinder.
Securely install the piston seal into the groove of the front disc brake cylinder.
4.INSTALL FRONT DISC BRAKE PISTON
| *1 | Cylinder Boot |
| *2 | Front Disc Brake Piston |
|
Lithium Soap Base Glycol Grease |
Apply a light layer of lithium soap base glycol grease to the entire circumference of a new cylinder boot.
Apply a light layer of lithium soap base glycol grease to the contact surfaces of the front disc brake piston.
Install the cylinder boot to the front disc brake piston.
Securely install the cylinder boot into the groove of the front disc brake piston.
Install the front disc brake piston to the front disc brake cylinder assembly.
Do not forcibly install the front disc brake piston into the front disc brake cylinder.
5.INSTALL CYLINDER BOOT
| *1 | Cylinder Boot |
Using SST and a hammer, install the cylinder boot to the front disc brake cylinder.
Securely install the cylinder boot into the groove of the front disc brake cylinder assembly.
Do not damage the cylinder boot.